Initial settings
29
Tone burst In the “Tone burst“ menu entry the following settings of the 22 kHz signal are pos-
sible:
Switching states on setting: Switching states on setting: Switching states on setting:
22 kHz signal —> High/Low and
Tone burst —> Pos. A/B: 22 k Hz signal —> Pos. A/B and
Tone burst —> Opt. A/B 22 kHz signal —> Pos. A/B and
Tone burst —> High/Low
Low
High 22 kHz
22 kHz Off
On Pos Tone burst 22 kHz Low
High Tone burst
Tone burst 0
1
Pos. 1
Pos. 2 Tone burst
Tone burst 0
1
1
2
3
4
0
0
1
1
Off
On
Off
On
Pos. 1
Pos. 2 22 kHz
22 kHz Off
On
DiSEqC Up to 16 inputs can be switched with the “DiSEqC“ control signal.
• If the receiver is connected up to a “DiSEqC" switch-over matrix, the menu entry
must be set to “On”.
Note For optimal usage it is essential to know the switching criteria and the input as-
signments of the DiSEqC switching matrices.
Thus take into account the specifications of the DiSEqC switching matrices or get
in touch with the installer of the receiving system.
DiSEqC repeat If the receiver is operated on a receiving system with two or more DiSEqC switch-
ing matrices connected in series (cascaded), the DiSEqC command must be re-
peated.
• In this case set the menu entry “DiSEqC Repeat" to “1" or “2“.
Default: Off
UFO mini With a “subscriber-controlled preprocessing system" the receiver‘s input frequency
is adjusted to a fixed input frequency. The signals are transmitted by the “sub-
scriber-controlled preprocessing system“ on this frequency. The reception pa-
rameters for the programme selection are transmitted by “DiSEqC“ command
to the receiving system and set up there.
Which setting needs to be selected "On" or “Twin“ is dependent on the design of
the “subscriber-controlled preprocessing system“.
The “UFO Twin“ design is a special form of the “subscriber-controlled preprocess-
ing system“
Note The setting is therefore to be made according to information in the “subscriber-
controlled preprocessing system“ installation guide.
Remote frequency
If you have set "On" or “Twin“ in menu entry UFO mini, make the setting in this
menu entry for the transmission frequency.
The particular transmission frequency that needs to be set for tuner A “TV“ and
tuner B “VCR“, in the range 0 to 2150 MHz, is given in the “subscriber-controlled
preprocessing system“ installation guide.
Note It is therefore essential to note the installation guide instructions of the “subscriber-
controlled preprocessing system“.