Page
51
ASSEMBLY INSTRUCTIONS
Caution y Ensure that this instruction manual is read thoroughly before attempting to assemble the CN piano, and that two or more people work on assembly.
yIt may be necessary to tilt the unit by 90 degrees while assembling the CN piano. During this time, ensure that hands are not caught in the piano, keyboard lid, or score stand, and that the piano is not dropped on an individual’s feet.
PARTS PROVIDED
Before attempting to assemble the CN piano unit, ensure that all parts are included. A
(A) Piano (x 1)
(B) Pedal board (x 1)
(C) End panel (x 1 each for left and right) | (E) | (F) | (G) | (H) | (I) | (J) | (K) |
Adjuster bolt | φ 4 x 16 | φ 4 x20 | φ 4 x30 | M6 x 25 | Cord clamp | Headphone hook and screws | |
(D) Back panel (x 1) |
|
|
|
|
|
|
|
(E) Adjuster bolt (x 1) |
|
|
|
|
|
|
|
(F) Screw:φ 4 x 16 (x 4) |
|
|
|
|
|
|
|
(G) Screw:φ 4 x 20 (x 4) |
|
|
|
|
|
|
|
(H) Screw:φ 4 x 30 (x 2) |
|
|
|
|
|
| Screw |
|
|
|
|
|
| (x 2) | |
|
|
|
|
|
|
| |
(I) Screw: M6 x 25 (x 4) |
|
|
|
|
|
|
|
(J)Cord clamp (x 2)
(K)Headphone hook and screws (x 1 set)
(L)Power cord (x 1)
ASSEMBLY SEQUENCE
Caution y Be careful not to scratch or damage the floor, piano, or stand at the time of assembly.
1.Screw the adjuster bolt (E) into the threaded screw hole provided on the pedal.
2.From the side of the screw that is already on the backside of the pedal board (B), slide and insert the bracket of the end panel (C).
3.While pressing the end panel (C) against the pedal board (B), tighten the
4.Untie and pull out the pedal cable.
5.Set the back panel (D) and tighten the screws (G) (H) into the prepared holes. Loosely tighten the screws with the * symbol.
1
(E)
2 y 3
| (F) |
(F)
(C)
(B)
APPENDICES
6
4 y 5
(H)* |
| (D) |
| (H)* |
(G) (G) (G)
(Untie this twist tie from the cable)
