Keating Of Chicago 2005 Iii Operating, T1 T2 T3, Electrical Connection, Conditioning The Griddle

ELECTRICAL

CONNECTION

Each Keating Top-Side™Cooking head is equipped with a 9' (2.74m) neoprene covered, 12 gauge 4mm(2), three wire with ground electrical cord. Each cooking head is rated 4000W, 18 amps, single phase at 220 Volts and is designed to be connected to its own 208- 240V single phase electrical supply. For proper connecting and grounding procedure see local codes, the National Electrical Code ANSI/NFPA 70 (latest edition) or Canadian Electrical Code CAN C22.1 (latest edition) as applicable.

THIS APPLIANCE MUST BE EARTHED.

III OPERATING

Food will cook much faster with a Top-Side™Cooker than with a griddle alone. Watch food while cooking or use timers to ensure food will not be overcooked.

OPERATION OF THE TOP-SIDE™COOKER SHOULD BE LIMITED TO PERSONNEL THOROUGHLY TRAINED IN OPERATING PROCEDURES.

CONDITIONING THE

GRIDDLE

The MIRACLEAN® Griddle plate has been “seasoned” at the factory. The chrome surface when heated creates a thin layer of chrome oxide which acts as a releasing agent for food products. If you feel you need to recondition the surface, the following instructions should be followed:

1.Follow cleaning instructions on this page & next.

2.Heat the MIRACLEAN® to 400°F for one hour.

3.Lower thermostat to 350°F, allowing the MIRACLEAN® to cool to about 350°F, as is evident when griddle cycles on or surface thermometer indicates correct temperature.

4.Lightly coat the MIRACLEAN® surface with griddle oil.

NOTE: Despite the food releasing properties, the chrome surface is not a true “non-stick” surface. For best cooking results and product appearance, use griddle oil for products that require the surface to be conditioned.

COOKING

1.Turn ON/OFF switch to “ON” position.

2.Press and hold the “Push to Set” button on the thermostat and adjust the knob to the desired temperature. The new temperature will be entered after 3 seconds. Red “ELEMENT ON” light will illuminate when the element is on.

NOTE: To increase temperature, adjust knob clockwise. To decrease, adjust knob counterclockwise.

Figure 3-1

Top-SideTMCooker Control Panel

COOKING HEIGHT

ADJUSTMENT

Keating’s Top-Side™Cooker has been designed to allow you infinite height adjustments from 1/8'' to 11/2 '' (approximately 3mm to 38mm). An adjusting knob allows fast and precise height adjustment.

Clockwise movement of the knob will decrease the spacing; counter clockwise movement will increase the spacing. Each turn of the adjusting knob represents 1/8'' (approximately 3mm) movement.

Experimentation will give you the best cooking height for each type of food product. The cooking head should contact the product firmly to ensure optimum heat distribution without flattening the product.

DIGITAL TIMER

PROGRAMMING FOR

AUTO-LIFT HEADS

ONLY

1-800-KEATING

T1 T2 T3

SET

The electronic timers provide a clearly visible and accurate display and are very easy to use. Three different, independent cook times can be set using this timer - T1, T2 and T3. When cook time has reached “00:00”, the cooking head will automatically raise.

2