ElectricalShockHazard Pluginto agrounded3 prongoutlet. Donot removegroundprong.
Donot usean adapter. Donot usean extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical connection:
To remove the base grille:
1.Open both refrigerator doors.
2.Place hands along the ends of the grille, with your thumbs along the top. Push in with your thumbs and pull up on the bottom.
NOTE: Be sure to refasten the Tech Sheet behind the base grille after cleaning.
To replace the base grille:
1.Open the doors.
2.Line up the grille support tabs with the metal clips,
3, Push the grille firmly to snap it into place.
Recommended grounding method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the control (Thermostat, Refrigerator or Freezer Control depending on the model) to OFF and then disconnect the refrigerator from the electrical source. When you are finished, reconnect the refrigerator to the electrical source and reset the control (Thermostat, Refrigerator or Freezer Control depending on the model) to the desired setting.
