Cleaning the dispenser drawer

The dispenser drawer can be removed for easy cleaning.

1.Unlock the dispenser drawer by pressing the Release Lever. See “Using the Dispenser.” Remove the drawer.

2.Remove the inserts (the siphon from the softener and bleach compartments).

3.Wash the parts under running water.

NOTE: Do not wash components in the dishwasher.

4.Replace the inserts and return the dispenser to the drawer.

Water Inlet Hoses

Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear or leaks are found.

When replacing your inlet hoses, record the date of replacement.

Vacation, Storage, and Moving Care

Install and store your washer where it will not freeze. Because some water may stay in the hoses, freezing can damage your washer. If storing or moving your washer during freezing weather, winterize it.

Non-use or vacation care:

Operate your washer only when you are at home. If you will be on vacation or not using your washer for an extended period of time, you should:

Unplug washer or disconnect power.

Turn off the water supply to the washer. This helps avoid accidental flooding (due to a water pressure surge) while you are away.

Slightly open door to provide ventilation.

To winterize washer:

1.Put 1 qt (1 L) of R.V.-type antifreeze in the drum.

2.Run washer on a Drain & Spin cycle.

3.Unplug washer or disconnect power.

4.Shut off both water faucets.

5.Disconnect water inlet hoses from faucets and drain.

To use washer again:

1.Flush water pipes.

2.Reconnect water inlet hoses to faucets.

3.Turn on both water faucets.

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

4.Plug in washer or reconnect power.

5.Run the washer through the Normal/Casual cycle with ¹₂ the manufacturer’s recommended amount of HE detergent for a medium-size load, to clean the washer and remove the antifreeze, if used.

To transport the washer:

1.If washer will be moved during freezing weather, put in 1 qt (1 L) of R.V.-type antifreeze in the drum. Run washer on a Drain & Spin cycle.

2.Unplug the power cord.

3.Disconnect the drain hose from the drain system and attach to rear panel clips.

4.Shut off both water faucets.

5.Disconnect the water inlet hoses from faucets, then drain the hoses and clip them to the rear panel of the washer.

6.IMPORTANT: Call service. Do not reuse transport bolts. Washer must be transported in the upright position. To avoid suspension and structural damage, your machine must be properly set up for relocation by a certified technician.

Reinstalling the washer

1.Follow the “Installation Instructions” to locate, level and connect the washer.

2.Run the washer through the Normal/Casual cycle with ¹₂ the manufacturer’s recommended amount of HE detergent for a medium-size load, to clean the washer and remove the antifreeze, if used.

22

Page 22
Image 22
Kenmore 110.4751 manual Water Inlet Hoses, Vacation, Storage, and Moving Care