Installation Instructions
STEP 14 SECURE DISHWASHER TO CABINET AND COUNTERTOP
To maintain position and alignment, the dishwasher must be secured to the countertop and adjacent cabinets.
Secure dishwasher to countertop:
•Drill pilot holes through the mounting bracket and into the underside of the countertop. Secure with screws A provided.
Screw A
IMPORTANT: To avoid damage to your dishwasher, drive screws straight and flush. Protruding screw heads may scratch the top of the escutcheon or door and can interfere with door closing.
Secure dishwasher to adjacent cabinets:
•Remove plastic plugs button on the inside of the dishwasher frame. One on each side.
•Drill pilot holes through the dishwasher holes and into the adjacent cabinets. Install screws B provided.
•Replace plastic plug buttons.
STEP 15 INSTALL TOEKICK
•Loosen depth adjustment screws inside the
bracket. | Adjust to |
• Slide bracket out | Toekick |
Depth | |
to proper depth. |
|
Tighten screws. |
|
•Attach supplied toekick to brackets with
screws C provided. Do not tighten.
• Adjust the toekick |
|
to touch the floor. | Attachment Screws |
Tighten screws. |
Adjust to Touch Floor
INSTALL A
CONTINUOUS
CUSTOM
TOEKICK
Notch the continuous toekick to allow the door panel to swing under the dishwasher.
A continuous custom toekick is recommended for models with long custom door panels.
•Cut a notch in the toekick deep enough to allow the door to swing freely under the dishwasher.
•Check for interference by slowly opening and closing the door. If the door touches the toekick, trim to prevent interference.
•Secure the toekick to adjacent cabinets in such a manner that it may be removed if service is required.
STEP 16 ADJUST SIDE TRIM STRIPS
Plug Buttons
Screw B
•Open the door fully.
•Loosen (but do not remove) screws holding the top and side trims.
•Adjust trim to cover opening gap. Tighten screws.
Adjust Side Trim to Meet Cabinetry
Loosen
Screws
14