Installation Preparation
PARTS SUPPLIED:
Remove the hardware accessory bag and other parts from inside or taped to the outside of the dishwasher. Check contents against illustrations to insure that all parts are included.
♦ |
|
| |
♦ 6 screws (see illustration) |
|
| |
♦ 2 leveling legs | Junction |
| |
♦ Template for the installation of a | Box Cover |
| |
with screws | 2 Leveling Legs | ||
custom panel packed with models | |||
|
| ||
ZBD7000 and ZBD7005 only |
|
| |
♦ Junction box cover |
|
|
Template |
for |
ZBD7000 |
ZBD7005 |
Only |
Template with Mounting Hardware
Screws A | Screws B | Screws C |
| |
(2) Countertop | (2) Cabinet | (2) Color |
| |
Mounting | Mounting | Matched | ||
Screws | Screws | Toekick | ||
Sound Insulation | ||||
|
| Screws | ||
|
|
|
PREPARE DISHWASHER ENCLOSURE
| This Wall Area |
| |
| must be Free of |
| |
34" to 35" | Pipes or Wires | 24" | |
Underside | Min. | ||
of Countertop |
|
| |
to Floor |
|
| |
|
| 6" | |
|
| ||
|
|
*Models ZBD7000 and ZBD7005 with custom panels are
•The floor inside the opening must be even and level with the finished floor of the kitchen. If the kitchen floor is tile, it may be
higher than the floor of the installation cutout. Pieces of wood may be placed into the cutout floor to make it level or higher than the room
floor. This will allow easy removal for any future service.
•The rough cabinet opening must be at least 24” deep,
Note: ADA installation, beneath 34" high countertops may be accom- plished by removing front leveling legs. Drain hose, water and electrical must be routed through the cutout on the back of the dishwasher.
•The dishwasher must be installed so that drain hose is no more than 10 feet in length for proper drainage.
•The dishwasher must be fully enclosed on the top, sides and back, but should not support any part of the enclosure.
Corner Installation
•When installing into a corner, allow 2" min. clearance between dishwasher and adjacent cabinet or wall.
•Allow
Clearance for Door Opening 2" Minimum
5