GE ZBD6605 Custom Panel Dimensions, CUSTOM PANEL FOR MODELS ZBD6400 ONLY, Toekick Installation

Custom Panel Dimensions

CUSTOM PANEL FOR MODELS

ZBD6400 ONLY

Panel kits must be ordered separately. Installation of any custom panel should be completed before the dishwasher is installed.

1/4" PANEL WITH ZPF625 TRIM KIT

	1/4" Thick
		25-	5/16"
1/4"	Door Panel
Radius
Cut

23-1/8"

•Cut the panel to the dimensions shown.

•The bottom left and right corners should be cut at 1/4" radius. See illustration.

3/4" PANEL WITH ZPF675 TRIM KIT

The custom panel size varies depending on your installation.

Countertop				Custom		Top
				Panel Size
	Cabinets				3/4" Thick
			A		Door Panel		*Height
			Floor			23-1/8"
		Bottom of		3/4" Max.

Adjacent Cabinetry

* Height is equal to A minus 5-1/4" plus 1/4"

EXAMPLE: A = 30-1/2" minus 5-1/4", plus 1/4" is equal to 25-1/2".

1.Measure Dimension A, from underside of countertop to bottom of adjacent cabinets.

2.Subtract 5-1/4”. Control panel height is 5". Allow 1/4" clearance between countertop and control panel.

3.Add 1/4". The custom panel slides up, behind control panel.

CUSTOM PANEL FOR MODELS

ZBD7000 AND ZBD7005

These models require a field installed 3/4" thick custom panel and custom handle. An installation template is packed with these models and may be obtained in advance. Order Pub. No. 49-5912. See page 15 for panel installation instructions.

Countertop		Custom
		Panel Size
Cabinets
Side	A
View
	Floor	B
Bottom of		3/4" Max.

Adjacent Cabinetry

STEP A: Determine custom panel height

1.Measure dimension A, from the underside of the countertop to the bottom of adjacent cabinets.

2.Subtract 1/4". This allows a 1/4" clearance gap between the underside of the countertop and the top of the dishwasher door.

HEIGHT = A – 1/4"

Note: 26-1/4" minimum panel height is required to cover the door frame. Panel height varies depending on installation. Consideration must be given to door swing clearance above the toekick.

STEP B: Determine custom panel width

1.Measure dimension B, the rough opening width.

2.Subtract 1/4" for clearance (1/8" on each side). WIDTH = B – 1/4"

Note: 23-1/8" minimum panel width is required to cover the door frame.

Toekick Installation

These dishwashers are supplied with a standard toekick. However, a notched continuous toekick is recommended to prevent door swing interference and to maintain toekick alignment with adjacent cabinets. See page 14 for details.

ADA Installations Beneath 34" Countertops

Use the same methods shown here to calculate door panel height. A notched continuous toekick will help to prevent door swing interference and maintain toekick alignment with adjacent cabinets.

9