Installation Instructions
STEP 5 INSTALL POWER CORD
SKIP THIS STEP IF DISHWASHER
WILL BE DIRECT WIRED
•Maximum power cord length is 6 ft.
•The power cord and connections must comply with the National Electrical Code, Section 422 and/or local codes and ordinances.
Insert power cord wires through strain relief and tighten.
Ground
White
Black |
•Strip 1/2" insulation from ends of power cord wires.
•Connect incoming power cord white to dishwasher white, black to black and ground to dishwasher green wire. Use UL listed wire connectors of appropriate size.
•Install junction box cover with screws provided. Be sure wires are not pinched under the cover.
STEP 7 SLIDE DISHWASHER INTO OPENING
DO NOT PUSH AGAINST THE FRONT PANEL WITH KNEES, DAMAGE WILL OCCUR!
•Insert drain hose into the cabinet wall hole. If a power cord is used, guide the end through a separate hole.
•Position water supply line and house wiring on the floor of the opening to avoid interference with base of dishwasher.
•Slide dishwasher into the opening a few inches at a time. As you proceed, pull the drain hose through the cabinet wall under the sink.
•Check to be sure there is no interference with waterline or house wiring.
•Again, check to be sure the dishwasher is level.
STEP 6 LEVEL DISHWASHER
•Carefully, upright the dishwasher, be careful not to bend the leveling legs.
•Check to be sure the dishwasher is level and is adjusted to fit the installation cutout height.
Level
Top and Sides
STEP 8 CONNECT WATER LINE
NOTE: If you are using an existing water line, cut 1" off the end. Always use a new ferrule and compression nut.
•The water supply line should be flushed to clear any foreign material before connecting to the dishwasher.
•Make sure there are no sharp bends or kinks to restrict water flow.
•Insert water line into the 90° elbow.
•Slide ferrule against
elbow and secure with | Compression Nut | |
Ferrule | ||
compression nut. | ||
• Replace access panel |
| |
plate. | Hot Water | |
| ||
| 90° Elbow Supply Line |
11