1.Unplug cord from wall outlet. DO NOT drip water on cleaner.
2.Clean exterior using a clean, soft cloth that has been dipped in a solution of mild liquid detergent and water, then wrung dry. Wipe dry after cleaning.
3.To reduce static electricity and dust build-
up, wipe outer surface of cleaner and attachments.
Do not use attachments if they are wet. Attachments used in
dirty areas, such as under a refrigerator, should not be used on other surfaces until they are washed. They could leave marks.
Check motor safety filter occasionally and change when dirty.
!L WARNING
Electrical Shock Hazard
Unplug power cord from electrical outlet. Do not operate the cleaner without the motor safety filter. Be sure the filter is dry and properly installed to prevent motor failure and/or electrical shock.
Remove the bag as outlined in the BAG CHANGING section.
MOTOR SAFETY FILTER ELECTROSTATIC
This white filter must be replaced when dirty. It should be replaced regularly
depending on use conditions. The filter CANNOT be washed as it wilt lose its
dust trapping ability.
NOTE: See PARTS AND FEATURES for
motor safety filter number.
1.Lift the rubber retainer and pull
out motor safety filter as shown.
2. Replace the fil- ter, rough side out, facing the dust bag, by sliding it back into place under the ribs in
the bag cavity.
Tuck filter in so that
it fits completely under the rubber
retainer.
3.Replace the bag as outlined in the BAG CHANGING section.
14
