Kenmore 116.25914, 116.25915 owner manual To Remove Belt, To Clean The Lenses

Although the dirt sensor feature in your Kenmore Power-Mate ® is designed for years of trouble free use, the passage of dirt through the air passage system can coat the lens causing the green light to come on and stay on - never switching to red. When this happens the lens must be cleaned.

Cross Section View

.fp_ox.

3 N inches _	Ring
or 90 mm

CAUTION

Never use water or any cleaning

solution when cleaning the lenses. The residue of the water or cleaners will

accelerate the recoating of the lenses and make cleaning necessary sooner.

TO CLEAN

THE LENSES

1. Remove the wand by pressing the quick release pedal and lifting up on the wand.

2.As indicated by

the illustration, the two dirt sensor elements are located on the inside of the swivel, approx- imately 3½ inches/90 mm down, (note the arrows). Each element should be cleaned peri- odically. To reach the sensor elements, use a small brush such as a bottle brush. Brush each sensor element several times to remove

dust and dirt.

NOTE: Looking down inside the swivel you will see a ring. The sensor elements are located just slightly below this ring.

3.Reinstall the wands after cleaning the sen- sors.

TO REMOVE BELT

	\	1. Turn Power-
		Mate ®	upside
		down.
		2. Unscrew the
		two (2)	Power-
		Mate ®	cover
		screws.
3. Turn	Power-
Mate ®	right

4. To remove cover,

grasp the sides and pull out.

5.Lift agitator assembly out and remove

side up. Press
handle	release
pedal	and

worn belt.

Base

lower	the
swivel.	Lift	Side	ear
rear latches		Latch	Latches

up.

6. Check and
clean end cap	End Cap
areas. See

AGITATOR ASSEMBLY for picture of complete agitator assembly.

t8