Kenmore 116.29915, 116.29914 manual Dirt Sensor, To Clean The Lenses

I DIRT SENSOR

Although the dirt sensor feature in your Kenmore PowerMate_ is designed for years of trouble free use, the passage of dirt through the air passage system can coat the lenses causing the green light to come on and stay on - never switching to red. When this happens the lenses must be cleaned,

, CAUTION

Never use water or any cleaning

solution when cleaning the lenses. The residue of the water or cleaners will

accelerate the recoating of the lenses

and make cleaning necessary sooner.

TO CLEAN THE LENSES

1oRemove the

wand from the
PowerMate by	_._-_	Wand
pressing the quick
release pedal and	!1t	Quick
lifting up on the		Release
wand,		Pedal

2.As indicated by the illustration, the two dirt sensor elements are located on the inside of

the swivel, approximately 3'½inchest90 mm down, (note the arrows),, Each element should be cleaned periodically To reach the sensor elements, use a small brush such as a bottle brush, Brush each sensor element several times to remove dust and dirt

Cross Section View

Ap_prox.,

3 ½ inches	. Ring
or 90 rnm
	i _Sensor

Elements

NOTE: Looking down inside the swivel you will see a ring.,The sensor elements are located just slightly below this r_ng,,

3.Reinstall the wand after cleaning the sen- sors.

22