Kenmore 116.29915, 116.29914 manual To Clean Agitator, Agitator Assembly

TO CLEAN AGITATOR:

NOTE: In order to keep cleaning efficiency high and to prevent damage to your vacuum cleaner, the agitator must be cleaned every+ time the belt is changed.

The agitator must also be cleaned accord- ing to the following schedule:

Vacuum Cleaner Use		_itator
HEAVY	-	every week
(used	daily)
MODERATE -
(used 2-3 timeslweek)		eveF_
LIGHT +		every 2 months_
(used	I time/week)

IMPORTANT

Turn off and unplug vacuum cleaner from electrical outlet, Check and remove hair,

string and lint build-up frequently in the PowerMate agitator and end cap areas.

Remove any dirt or debris in the belt path area or in the brush roller area,,

Carefully remove any stdng or debris located on the agitator or end caps,

AGITATOR ASSEMBLY

_ End Cap	Belt Path q
Brush Unit	End Cap _

then over be	Drive
path.

Agitator End Cap

NOTE: See PARTS AND FEATURES for Belt number,

2oPlace agitator

assembly into PowerMate.

3. NOTE: On dirt sensor models be sure that the dirt sensor board is upright and the wires are tucked back in place

4+Line up front of cover and base Rest cover on front edge of base as shown,

5.Rotate cover

back., Press cover firmly until side latches snap into

place+"",

6.Make sure there is no gap between the cover and base and that the rear latches

are snapped in place,,

7, Turn PowerMate upside down and replace two (2) cover screws,

2O