Electrical Shock Hazard
Unplug power cord from electrical
outlet. Do not operate the vacuum cleaner without the primary or
exhaust filters. Be sure the filters
are properly installed to prevent motor fadure and/or electrical shock.
PRIMARY FILTER
Check primary filter frequently and clean when dirty.
TO REMOVE PRIMARY FILTER
Remove the dust bin and dust bin lid
assembly as outlined in the DUST BIN CLEANING section.
While holding | ClHning Cam |
pdmary filter | Slot |
over a trash con- | Filter |
tainer grasp filter, |
|
rotate and lift off. |
|
Clean primary fil-
Locking Tab
tar by gently tap- Filter Cover ping over a trash
container. Tap on several sides to ensure best cleaning. Rinse with water only as needed, do not use any detergent or soap. Allow the filter to dry for 24 hours before putting it back into the vacuum cleaner.
When cleaning the filter no longer restores vacuum suction to full power you need to replace the filter.
Note: See PARTS AND FEATURES for the filter number.
TO REPLACE PRIMARY FILTER
EXHAUST FILTER
HEPA
The exhaust filter must be replaced when dirty. It should be replaced regularly depending on use conditions.
The filter CANNOT be washed as it will lose its dust trapping ability.
Note: See PARTS AND FEATURES for the filter number.
Remove filter cover by pulling out at the top of the exhaust filter cover.
I I!
Remove the exhaust filter cartridge.
Exhaust
Filter Seal
With slot side on filter towards the filter cover slide cleaning cam
inside opening, rotate filter clock-
wise until slots lock onto tabs in cover.
Cleaning Cam
Slot
Filter
Locking Tab Filter Cover
Push only on filter cartridge frame, not on filter material itself. The foam seal of the
filter should be placed against the vacu- um cleaner body
Note: Under normal use and care, your fil- ter can be expected to last up to 5 years.
Replace the exhaust filter cover by placing bottom tabs in slots and pushing in until cover snaps into place.
16
