WARNWNG
Electrical Shock Hazard
Unplug power cord from electrical out- let. Do not operate the vacuum cleaner without the motor safety filter. Be sure
the filter is dry and properly installed to
prevent motor failure and/or electrical shock.
MOTOR SAFETY FILTER
Check motor safety filter frequently and clean when dirty,
Motor Safety
Filter
Filter Element
The HEPA exhaust filter must be replaced when dirty, it should be replaced regularly depending on use conditions°
The filter CANNOT be washed as it will lose its dust trapping ability,
Note: See PARTS AND FEATURES for the exhaust filter number,
Remove exhaust filter cover by pressing the release tab on the cover and rotating out from vacuum cleaner.
| Remove |
Filter Cover | the filter |
Release Tab | cartridge |
| from cover, |
Remove the dust bag as outlined in the DUST BAG REPLACEMENT section,
If the filter, located in the bottom of the dust cover cavity, is dirty, remove it by pulling for- ward out from under the ribs,
Wash the foam filter in warm soapy water, rinse and dry thoroughly by squeezing the fil- ter in your hand and letting it air dry.
DO NOT wash in the dishwasher.
DO NOT install damp.
Replace the foam filter by sliding it back into place under the ribs in the dust cover cavity.
Replace the dust bag as outlined in the DUST BAG REPLACEMENT section,
The foam seal of the filter should be placed against the vacuum cleaner
body,
Exha us t
Filter
SeaI Against
Vacuum Cleaner
Body
/
LExhaust
Filter
Replace the exhaust filter cover by placing bottom tabs in slots and rotating in until cover snaps into place,
Place new filter cartridge into cover making sure that airflow arrow on side of cartridge points into cover,
18