Kenmore 116.35923, 116.35922 owner manual Sears or other qualified service agent

Review this table to find do-it-yourself solutions for minor performance problems, Any service needed, other than maintenance described in this Owner's Manual, should be performed by a

Sears or other qualified service agent°

I Disconnect electrical supply before performing maintenance to the vacuum clean e r.

_ Failure to do so cou_ld .result in electrical shock or personal injury. .................

Vacuum cleaner	1.	Unplugged at wail outlet,	1.	Plug in firmly, select the desked set-
won't run.				ting on the touchcontrol
	24	Tripped circuit breaker!blown fuse	2.	Reset circuit breaker or replace fuse
		at household service pane].
	3,	Thermal protector tripped°	3.	Allow vacuum cleaner to cool, then
				_esetthermal protector.
	4,	Defective wall outieL	4_	Check with a good appliance/lamp,
				have properly serviced

Poor jobof dirt

plck-upo

5., Handle screw not tight.

1.Full or clogged dust bag.

2.Wrong pile height setting.

3o Worn agitator,

4.Clogged nozzle or bag holder. 5, Clogged hose.

6.Hole in hose.

7.Broken/misplaced bell 8, Hose not inserted fully.

9.Motor protection system activated. t0, Dirty filters.,

5, Tighten screw.

1.Change bag

2.Adjust setting,

3.Replace agitator

4, Check CLOG REMOVAL..

5.	Check for clogs,
6.	Replace hose
7.	Replace/fix		belt.
8.	Insert	hose	fully.
9.	Check	for clogs,
10.	Clean or change motor salety filter
	and exhaust		filter

Vacuum Cleaner			picks up	1_ Wrong pile height setting,
moveable		rugs or
pushes	too hard.
Light won'twork.				1.	Burned out light bulb.
Agitator	does not		turn.	1.	Handle in full upright posilion,
				2,	Agilalor Overload tripped,
				3.	Thermal protector tripped,,
Airflow	restricted			1.	Attachment use restricts air flow_
with attachment user
Sound	changes,			2.	New carpet fuzz clogged air path.
Difficulty		adjusting pile		1.	Vacuum cleaner not in proper upright
height	setting				positron,

t. Adjust setting,

Change Iight bulb.

1. Move handle trom upright position,,

2o Reset Agitator Overload.

3_ Allow vacuum cleaner to cool 40-50 minutes

1, Check ATTACHMENTS for tuzz. lint.

pet hair or other debris

2.Check CLOG REMOVAL and clean tlose,

Place vacuum cleaner in the locked

upright position, tilt the vacuum cleaner back slightly and adjust pile heighl,

21