Kenmore 116.36932, 116.36933 owner manual To Replace Primary Filter, Replace Dust BIN LID

, , ,, , , ,,, ,,,,,

IbWARNING

Electrical Shock And Personal Injury

Hazard

Unplug power cord from electrical out- let. Do not operate the vacuum cleaner without the primary or exhaust filters. Be sure the filters are properly installed to

prevent motor failure and or electrical shock.

PRIMARY FILTER

Check primary filter frequently and clean when dirty.

TO REMOVE PRIMARY FILI'ER

Remove the dust bin assembly as outlined in the DUST BIN CLEANING section.

Make sure dust bin is free of debris before removing lid and filter. Rotate dust bin lid assembly counterclockwise as indicated on the lid and lift off.

Turn This Direction

To Open For Emptying

Closed

(For Use)

Open

(For Emptying)

While holding dust bin lid over a trash con- tainer grasp primary filter, rotate counter- clockwise and lift off_

Clean primary filter by gently tapping over a trash container, Tap on several sides to ensure best cteaning_

Remove		primary
filter	by	turning		Dust Bin
it counterclock-				Lid
wise	and pulling
out	(See	arrows
on bottom of ill-
ter),, Rinse			with
water only			as
needed,		do	not
use	any	deter-
gent	or	soap.

Allow the filter to dry for 24 hours before putting it back into the vacuum cleaner,

When cleaning the filter no longer restores vacuum cleaner's suction to full power you need to replace the filter.

Note: See PARTS AND FEATURES for the filter number..

TO REPLACE PRIMARY FILTER

To replace filter, insert it over cleaning cams as far as it will go. Make sure rubber seal at top of filter is flush against filter sup- porter, then turn filter clockwise to secure into place. Filter wilt click and snap when it is secured into place.

Note: Under normal use and care, your fil- ter can be expected to last up to 5 years.

Rubber

Cams

Dust Bin

Lid

Re-assemble dust bin lid to dust bin. see To

REPLACE DUST BIN LID.

18