Kenmore 153.318131 Waterou, Water Piping, Installation Completed Using The Installation Kit, Pipe

Installation Instructions (cont'd)

Water Piping

*AWARNING

HOTTER WATER CAN SCALD: Water heaters are

intended to produce hot water. Water heated to a tem- perature which will satisfy space heating, clothes wash- ing, dish washing, and other sanitizing needs can scald and permanently injure you upon contact. Some people are more likely to be permanently injured by hot water than others. These include the elderly, children, the

infirm, or physically/mentally handicapped. If anyone using hot water in your home fits into one of these

groups or if there is a local code or state law requiring a

certain temperature water at the hot water tap, then you must take special precautions. In addition to using

the lowest possible temperature setting that satisfies your hot water needs, a means such as a mixing valve, shall be used at the hot water taps used by these people or at the water heater. Mixing valves are available at

plumbing supply or hardware stores. Follow manufactur- ers instructions for installation of the valves. Before

changing the factory setting on the thermostat, read the "Temperature Regulation" section in this manual.

HOT WATER A	COLD WATER
OUTLET J

TEMPERED
WATEROU	ro COLD WATER
FROM HOT	INLET ON
	WATER HEATER
*MIXING VALVE WATER OUTLET
ON WATER HEATER

Look at the top cover of the water heater. The water outlet is marked hot. Put two or three turns of teflon tape around the threaded end of the threaded-to-sweat coupling and around both ends of the _" threaded nipple. Using flexible connec-

tors, connect the hot water pipe to the hot water outlet on the water heater.

Look at the top cover of the water heater. The cold water inlet is marked cold. Put two or three turns of teflon tape around the threaded end of the threaded-to-sweat coupling and around both ends of the _" threaded nipple. Using flexi-

ble connectors, connect the cold water pipe to the coldwater inlet of the water heater.

NOTE: Your water heater is super insulated to minimize heat loss from the tank. Further reduction in heat loss

can be accomplished by insulating the hot water lines from the water heater.

INSTALLATION COMPLETED

USING THE INSTALLATION KIT

FLEXIBLE

WATER

CONNECTORS

3/4"

NIPPLE"THREADED NIPPLE

VALVE

_THREADED TO

' SWEAT COUPLING

NOTE: This piping arrangement would convenient location away from the table

have to be done at some top water heater.

		INLET
		WATER
The illustration shows the attachment of the water piping to the		LINE
water heater. The water heater is equipped with Yd'water con-
nections.
If a water heater is installed in a closed water supply system;
such as one having a back-flow preventer, check valve, water
meter with a check valve, etc...in the cold water supply; means
shall be provided to control thermal expansion. Contact the	DISCHARGE _
	PIPE
local utility or Sears Service Center on how to control this situa-	(Do	not cap
tion.	or	plug)

NOTE: If using copper tubing, solder tubing to an adapter before attaching the adaptor to the cold water inlet connec- tion. Do not solder the cold water supply line directly to the

cold water inlet. It will harm the dip tube and damage the tank.

•_I_keoff the cabinet top to make all the water and electrical connections. Pull the cabinet top forward, all the way until it is free. xY./henreplacing the top, put it on the clips, almost to the back, push down and then push back.