18.Replace access panel,
19.Turn "ON" electric power to water heater,
Drain Valve Washer Repmacement
[
Before removing any access panels or servicing the water heater, make sure the electrical
supply to the water heater is turned "OFF".
Failure to do this could result in death, serious bodily injury, or property damage.
NOTE: For replacement, use a 17/32" × 13164 °'× 1/8" thick
washer available at your nearest hardware store. For
ordering a replacement washer, refer to the "Parts Order List" section.
Before beginning turn "OFF" the electrical power supply to the water heater.
Follow "Draining" instructions. See "Draining" section.
*Turning counter clockwise, remove the hex cap below the screw handle.
*Remove the washer and put the new one in place.
*Screw the handle and cap assembly back into the drain
valve and retighten using a wrench. DO NOT OVER TIGHTEN.
Follow "Filling the Water Heater" instructions in the
"lnstaflation Instructions" section.
*Check for leaks.
Turn "ON" electric power to the water heater.
_"_ HANDLEAND
CAP ASSEMBLY
WASHER
FIGURE 42.
Service
Before calling for repair service, read the "Start Up Conditions"
and "Operational Conditions" found in the Troubleshooting section of this manual.
If a condition persists or you are uncertain about the operation of the water heater, let a qualified person check it out.
Contact Sears Repair Services at l oS00o4oMyoHOME (1 o800o469o4663).
22
