Kenmore 153.332562, 153.332462 Contd, High Temperature Shut OFF System, Water is TOO HOT, Problem

Troubleshooting Guide (cont'd)

Operational Conditions

(cont'd)

HIGH TEMPERATURE SHUT OFF SYSTEM

This water heater is equipped with an automatic gas shut offsys- tern. The high temperature shut offis built into the gas control valve. This system shuts off the gas supply to the water heater burners when high water temperatures are present. It is non- resettable, tf the high temperature shut off activates, the gas con- trol valve must be replaced. If this were to occur, turn "OFF" the entire gas supply to the water heater. Contact the Sears Service Center.

WATER IS TOO HOT

•The temperature adjustment dial may be set too high. See the ' Temperature Adjustment section.

NOTE: A period of time is necessary after an adjustment has been made for the water temperature to reach the new tem- perature setting.

•If lower temperature settings will not lower the water tempera- ture, call the Sears Service Center.

_,WARNING Shouldoverheatingoccuror the gassupply fail to shut off,

turn OFF the manualgascontrn valveto the app an€e,

NOT ENOUGH OR NO HOT WATER

:Check the manual gas shut offvalve to be sure it is open. Check the pilot flame. It may have gone out. All models have an opening behind the outer door for viewing the pilot.

•If the pilot is not lit, follow the "Lighting" instructions in this manual are located above the gas control valve on the water heater to relight thepilot. If the water was extremely hot and is now cold, the high rJmit safety temperature shut off may have put out the burner and pilot. If the high temperature shut off activates, the gas controlvalve must be replaced. Contact the Sears Service Center.

The gas control knob must be turned to the "ON" position.

•The temperature adjustment dial may be set too low. See the "Temperature Regulation" section.

The gas company can check the gas input to see if it is correct.

iAn underfired water heater will not heat water as quickly.

Look for leaking or open hot water faucets. Make sure all are closed.

•The cold water inlet temperature may be colder during the

winter months. It will take longer to heat the water and seem like less hot water.

•If you cannot find what is wrong, call the Sears Service Center.

AWARNING

HOTTER WATER CAN SCALD:Water heatersare intendedto producehot water. Water heated to a temperature whichwill satisfyclotheswashing,dishwashing,and other sanidzingneeds can scaldandpermanentlyinjureyou upon conta_ Some peo- ple are more likelyto be permanentlyinjuredbyhot water than other_ These includethe elder_, children,the inllrm, or physicaJ- ly/mentally handicappedIf. anyoneusinghotwater in yourhome fitsinto oneof these groupsor if there isa localcodeor state law requiringa certaintemperaturewater at she hot water ta_ then you must take specialprecaudon_In additionto usingthe lowest possibletemperature settingthat satisfiesyour hot water needs,

ameanssuchas a mixing valve,shouldbe usedat the hot water taps usedby these people or at the water heater. Mixingva/ves are availableat plumbingsupplyor hardwarestoreL Followman- ufatturers instructions for installation of the valves. Before

changing the factory setting on the thermostat, read the 'q'emperatureRegulation"sectionin this manual.

AWARNING

Due to the nature of the typical gas water heater, the water temperature in certain situations may be hotter

than the thermostat setting.

Short, frequent draws of hot water - especially with very ¢old incoming water - can shock the thermostat into brief operation resulting in hotter and hotter layers of water closer to the top of the tank.

Changes in hot water usage patterns or raising the tom- perature differential between the cut-on of the thermo- stat and the cold water temperature will usually eliminate

!the problem.

24