Installation Instructions (cont'd)
Water Piping
AWARNING
HOTTER WATER CAN SCALD:.Water heatersare intendedto
producehot water.Water heatedto a temperature .whichwill saUsfyclotheswashing,dishwashing,and othersanitizingneeds; canscaldand permanentlyinjureyou uponcontact.Somepeo- Poleare more likelyto be permanentlyinjuredbyhot water than
rs. Theseincludetheelder_,children,the infirm,or physical.
ly/mentally handicappedIf. anyoneusinghotwater in your home fitsintoone ofthese groupsor if there isa localcodeor statelaw
requiring a certaintemperaturewater at the hot w_er taR then you must take specialprecautionsIn. additionto usingthe lowest possib/etemperaturesettingthat satisfiesyour hot water needs, a meanssuchasa mixingvalve,shouldbe usedat the hot water tapsusedby these peopleor at the water heater.Mixingvalves areavailableat plumbingsupplyor hardwarestores.Followman- ufacturers instructionsfor installationof the valves. Before changing the factory setting on the thermostat, read the "Temperature Regulation"sectionin this manual.
This water heater shall not be #onnected to any heating systems
or component(s) used with a
If a water heater is installed in a closed water supply system; such as one having a
shall be provided to control thermal expansion. Contact the
local utility or local Sears Service Center on how to control this situation.
NOTE: Toprotect against untimely corrosion of hot and
cold water fittings, it is stronl_ly recommended that
The illustration shows the attachment of the water piping to the water heater. The water heater is equipped with ¾ inch water connections.
NOTE: If using copper tubing, solder tubing to an adapter
before attaching the adapter to the cold w,.ater'.mlet connec- tion. Do not solder the cold water supply llne directly to the
cold water inlet. It will harm the dip tube and damage the tank.
•Look at the top cover of the water heater. The water outlet is marked hot. Put two or three turns of teflon tape around the
threaded end of the
tors, connect the hot water pipe to the hot water outlet on the water heater.
Look at the top cover of the water heater. The cold water
inlet is marked cold. Put two or three turns of" teflon tape
around the threaded end of _e
NOTE: This water heater is super insulated to minimize heat loss from the tank. Further reduction in heat loss
can be accomplished by insulating the hot water lines from the water heater.
INSTALLATION COMPLETED USING
SEARS INSTALLATION KIT
| FLEXIBLE |
|
| WATER | SHUTOFF |
| CONNECTORS | VALVE |
HOT OUTLET |
|
|
|
| WATER LINE |
TO HOUSE | / | COLD, ; |
THREADED TO | THREADED TO | |
SWEAT | COUPLING | SWEAT COUPLING |
3/4" THREADED | 3/4" THREADED | |
COUPLING | COUPLING |
PRESSURE
RELIEF VALVE
| DISCHARGE | |
[] | PIPE (Do not cap | |
or plug) | ||
|
6" AIR GAP
FLOOR DRAIN
11