![](/images/new-backgrounds/1009543/954325x1.webp)
There are two motor safety filters: 1. a dark foam filter incorporated in the red frame and 2. a white electrostatic filter that is laid on the back side of the dark foam filter
These filters should be checked with each bag change. The dark foam filter can be washed, per the instructions below and the white filter must be replaced when dirty
WARNING
Electrical Shock Hazard
Do not operate the cleaner without the motor safety filter. Be sure the filter is dry and properly installed to prevent motor failure and/or electrical shock.
from wall outlet andI. Unplugremovecord
2, Pull out safe-
ty filters as shown
3, Peel | the white |
|
|
| |
filter | off | the dark |
|
| _ f |
foam | filter as | White |
| ||
shown | Lay a new |
| |||
Electrostaticr_ | .i | ||||
white | filter on the | Filter | '. |
| |
dark filter by align- |
|
|
| ||
ing the | notches in | Dark Foam |
|
| |
the filter | with the | Filter |
|
| |
tegs | of the frame. |
|
|
|
The new filter can be purchased under part number 4369971 at your local Sears
Service Unit,
DARK FOAM FILTER
This filter and the frame can be washed in
warm soapy water, rinsed and air dried. DO NOT clean in a dishwasher or clothes
washer or install while damp.
WHITE ELECTROSTATIC FILTER
This filter must be replaced when dirty. It should be replaced regularly depending on use conditions. The filter CANNOT be washed as it wilt lose its dust trapping ability.
1.Unplug cord from wall outlet. DO NOT drip water on cleaner.
2.Clean exterior using a clean, soft cloth that has been dipped in a solution of mild
liquid detergent and water, then wrung dry. Wipe dry after cleaning.
3.To reduce static electricity and dust build- up, wipe outer surface of cleaner and attachments.
4. Snap filter back into canis- ter.
5. Insert bag
DO NOT USE ATTACHMENTS 1FTHEY ARE
WET_
CAUTION
I ttachments used in dirty areas, such as under a refrigerator, should not be used on other surfaces until
they are washed.They could leave marks.
13