Kenmore 1T6.29429 manual To Replace Belt, Parts and Features, For Bett #

5.Carefully insert and

twist screwdriver at each brush

support to free brush

from base.

Base

Brush

Support i

i

TO REPLACE BELT:

6.Remove worn belt.

7.Slide brush

supports off to check and clean brush support areas. See

BRUSH ASSEMBLY for picture of complete brush assembly

1.Slide washers brush assembly

new belt over2. Installmotor drive, then

oversprocketbrush.

NOTE: See

PARTS AND FEATURES

for Bett #

4.Line up front of cover and base. Rest cover

on front edge of base as shown.

and brush supports onto

Motor

Drive

Brush Brush Sprocket

Support

3.Snap brush supports into

place on base. Be sure brush

supports are

not upside- down.

L_

CoverBase

5.Tilt cover to back° Press

cover firmly until side tabs snap into place. Replace cover screws, light bulb and light

COVeL

15