Kenmore 1T6.29429 manual To Remove Belt, Electrical Shock Or Personal Injury Hazard, Changing

cleaningandservicingthePOWER-MATETM

WARNING

Electrical Shock Or Personal Injury

Hazard

1, Remove light

cover by pressing in and lifting both sides as shown_

Disconnect cleaner from electrical outlet. Check and remove hair, string and lint buildo up frequently in the POWER-MATETM brush and brush support areas, tf build-up becomes excessive, disconnect POWER- MATE TM from wand and follow the steps below_ Instructions can also be found under the light cover,

TO REMOVE BELT:

Disconnect electrical supply before servicing or cleaning the unit, Failure to do so could result in elec- trical shock or personal injury from cleaner suddenly starting,

• !iiiii!!ii!ii!i!i!!iTMil

Push In	2, Push in and turn
And Turn	bulb counterclock-
	wise to remove_
	3. Replace		the bulb,
	Bulb must		not be
	higher	than	15 Watts
	Close	light	cover until
	it snaps in place.

NOTE: See PARTS AND FEATURES for Bulb #

3.Turn

POWER- MATE TM over. To remove cover, insert screwdriver at cover tabs on both sides and twist to release tabs.

--'-I

cover and light bulb as shown under LIGHT BULB

CHANGING.

1. Remove light

2. Unscrew the

POWER- MATE TM cover screws.

4, Turn POWER- MATE TM right side uF Press handle release pedal and lower the swivel Tilt cover forward from back until front snaps free,

14