Kenmore Refrigerator, 2200128 Please Read Before Installation, Remove Screw 2 AS Shown in Diagram

I

4.Disassemble right top hinge.

•Remove hinge cover and screws. DO NOT

REMOVE SCREW 2 AS SHOWN IN DIAGRAM.

•Lift door up off bottom hinge.

i

i

I i i

i

i

i

5.Remove bottom hinge, if necessary. Both bottom hinges have similar construction. DO NOT REMOVE SCREW 3 AS SHOWN IN DIAGRAM.

NOTE: It may not be necessary to remove the bottom hinge to move refrigerator through a doorway.

J

6.Replace doors.

7.Plug in refrigerator or reconnect power.

Apply firm pressure with hand on face of trim. Slide top

trim up and bottom trim down away from handle, then lift off of shoulder screws. Remove screws.

j

f

PLEASE READ BEFORE INSTALLATION

Immediately after installation, follow the steps below to make sure that the water system is properly cleaned.

1.Turn off the ice maker by opening the freezer door and lifting up the signal arm as shown.

2.Flush the water system by dispensing and discarding 2 - 3 gallons (approximately 6-7 minutes) of water through the dispenser. This will clean the system and help clean air from the lines. Additional flushing may be required in some households.

7