Kenmore 300 Series, 300 Series warranty Specifications, Bypass Valves, Inches

Specifications

F

B

A

	BYPASS VALVES
	Bypass valve(s) should always remain in soft water
	service position. Position in “bypass” only if needed for
	softener repairs.
	SINGLE BYPASS
	pull stem
E	outward for
	service
D
C
	push
	inward for
	bypass

		Inches	CM	3 VALVE BYPASS		Bypass
				FOR SERVICE		valve
A	Salt Tank Height	40-1/4	102.2
				close bypass valve
				open inlet & outlet valves
B	Resin Tank Diameter	8	20.3
	(nominal)			FOR BYPASS	Outlet
				open bypass	valve	Inlet
C	Resin Tank Height (nominal)	40	101.6
				close inlet & outlet		valve
D	Inlet-Outlet Height	41-1/2	105.4
E	Overall Height	47-3/4	121.3
F1	Length	19-3/4	50.2
F2	Width	16-1/2	41.9
-	Distance between inlet-outlet	3-3/8	8.6
	centerlines					FIG. 44

MODEL 38306 TIMER CODE S 25

MODEL 39306 TIMER CODE S 26

WATER SUPPLY TO WATER SOFTENER	MODEL 38306		MODEL 39306
Minimum water system flow (gpm)	3		3
Minimum-maximum water pressure (psi)	20 - 125		20 - 125
Minimum-maximum water temperature (°F)	40 - 120		40 - 120
Maximum water hardness (gpg)	95		95
Maximum “clear water” iron (ppm)*	7		7
SALT FOR WATER SOFTENER
Type of salt needed		nugget or pellet
Alternate type of salt	pure, evaporated, compacted water softener salt

gpm = gallons per minute psi = pounds per square inch

gpg = grains per gallon ppm = parts per million

*Capacity to remove clear water iron is substantiated by WQA test data. State of Wisconsin requires additional treatment if water supply contains greater than 5 ppm clear water iron.

Questions? Call The Kenmore Water Line 1-800-426-9345

32