D.AnexcessofactivehydrogeninthetankThisiscausedby.
corrosionprotectiveactionoftheanode.
Smellywatermaybeeliminatedorreducedin somewater heatermodelsbyreplacingtheanoderod(s)withoneofless activematerial,andthenchlorinatingthewaterheatertankand allhotwaterlinesContactthelocalSearsServiceCenterfor.
furtherinformationconcerninganAnodeReplacementKit #9001453andthisChlorinationTreatmentAnodereplacement. andchlorinationofthetankarenotcoveredbythewater heater'slimitedwarranty.
Ifthesmellywaterpersistsaftertheanodereplacementand chlorinationtreatment;thenyoushouldconsiderchlorinating oraeratingyourwatersupply.
Do not remove the anode leaving the tank unprotected. By
doing so, all warranty on the water heater tank is voided.
I
® Before removing any access panels or servicing the water heater, make sure the electrical
supply to the water heater is turned "OFF".
"Failure to do this could result in
death, serious bodily injury, or property damage.
1.Before beginning, turn "OFF" electrical power supply to the water heater.
"AIR" IN HOT WATER FAUCETS
Explosion Hazard
• Flammable hydrogen gases may be present.
. Keep all ignition sources away from faucet when turning on hot water.
HYDROGEN GAS: Hydrogen gas can be produced in a hot water system that has not been used for a long period of time
(generally two weeks or more). Hydrogen gas is extremely
flammable and explosive. To prevent the possibility of injury
under these conditions, we recommend the hot water faucet be opened for several minutes at the kitchen sink before any
electrical appliances which are connected to the hot water system are used (such as a dishwasher or washing machine). If hydrogen gas is present, there will probably be an unusual sound similar to air escaping through the pipe as the hot water faucet is opened. There must be no smoking or open flame near the faucet at the time it is open.
RUMBLING NOISE
In some water areas, scale or mineral deposits will build up on your heating elements. This buildup will cause a rumbling
noise. Follow "Element Cleaning/Replacement" instructions to clean and replace the elements.
HIGH TEMPERATURE SHUT OFF SYSTEM
The water heater has a high limit shut off system with a reset button located on the thermostat.
Follow the resetting instructions which refer to the high limit behind the access panel.
NOTE: If your water heater is connected to an "Off Peak" Clock,
and uses the "3 wire lead" wiring diagram in the "Wiring Diagram" section, then the water heater will have a high limit
on both the upper and lower thermostats. Follow the instructions to reset the
FIGURE 44.
2.Remove the two screws securing the access panel and remove panel.
3.Remove the insulation cap with handle.
4.Reset the high limit by pushing in the red button marked "RESET".
RESET
FIGURE 45.
5.Replace the insulation cap with handle so that it completely covers the thermostat and element.
6.Replace the access panel.
7.Turn "ON" electric power to the water heater.
If the high limit must be reset again, call Sears Service Department to find out why the high limit turned "OFF" the electric power
NOT ENOUGH OR NO HOT WATER
In a new installation, the water heater may not be properly connected. Make sure the cold water supply valve is open.
Review and check piping installation. Make sure that the cold water line is connected to the cold water inlet to the
water heater and the hot water line to the hot water outlet on the water heater.
24
