Facts to Consider About

the Location

Carefully choose an indoor location for the new water heater, because the placement is a very important consideration for the safety of the occupants in the building and for the most economical use of the appliance. This water heater is not for use in manufactured (mobile) homes or outdoor installation,

Whether replacing an old water heater or putting the water heater in a new location, the following critical points must be observed:

Select a location indoors as close as practical to the gas vent or chimney to which the water heater vent is going to be connected, and as centralized with the water piping system as possible.

Selected location must provide adequate clearances for servicing and proper operation of the water heater.

Property Damage Hazard

Allwaterheaterseventuallyleak

De notinstallwithout adequatedrainage

Installation of the water heater must be accomplished in such a manner that if the tank or any connections should leak, the flow will not cause damage to the structure. For this reason, it is not advisable to install the water heater in an attic or upper floor. When such locations cannot be avoided, a suitable drain pan should be installed under the water heater. Drain pans are available at your local Sears or hardware store. Such a drain pan must have a minimum length and width of at least 2 inches (51 mm) greater that the water heater dimensions and must be

piped to an adequate drain. The pan must not restrict combustion air flow.

heater's pilot light or main burner. The resulting flashback and fire can cause death or serious burns to anyone in the area. Even though this water heater is a flammable vapors ignition resistant water heater and is designed to reduce the chances of flammable vapors being ignited, gasoline and other flammable substances should never be stored or used in the same vicinity or area containing a gas water heater or other open flame or spark producing appliance.

Also, the water heater must be located and/or protected so it is not subject to physical damage by a moving vehicle.

For continued protection against risk of fire:

• Do not install water heater on

I i_carpeted floor,

Fire Hazard

Do not operate water heater if flood damaged.

This water heater must not be installed directly on carpeting. Carpeting must be protected by metal or wood panel beneath the appliance extending beyond the full width and depth of the appliance by at least 3 inches (76.2 mm) in any direction, or if the appliance is installed in an alcove or closet, the entire floor

must be covered by the panel. Failure to heed this warning may result in a fire hazard.

Fire or Explosion Hazard

using or servicing water heater.

Improper use may result in fire or explosion.

Maintain required clearances to combustibles.

Fire or Explosion Hazard

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance,

Avoid all ignition sources if you smell LP gas.

Do not expose water heater control to excessive gas pressure

Use only gas shown on rating plate.

Maintain required clearances to combustibles,

Keep ignition sources away from faucets after

installing, using or servicing

,, extendedReadperiodinstructionof non-usemanual. before water heater.

INSTALLATIONS IN AREAS WHERE FLAMMABLE LIQUIDS (VAPORS) ARE LIKELY TO BE PRESENT OR STORED

(GARAGES, STORAGE AND UTILITY AREAS, ETC.): Flammable liquids (such as gasoline, solvents, propane [LP or butane, etc.] and other substances such as adhesives, etc.) emit flammable vapors which can be ignited by a gas water

Minimum clearances between the water heater and combustible

construction are 0 inch at the sides and rear, 4 inches (102 mm) at the front, and 6 inches (153 mm) from the vent pipe, see Figure 8. Clearance from the top of the jacket is 12 inches (305 mm) on most models. Note that a lesser dimension may be allowed on some models, refer to the label attached adjacent to the gas control valve on the water heater.

TOP VIEW

TOP

VIEW

OF CLOSET

OF CLOSET

WITHOUT DOOR

WITH

DOOR

I I 0" MIN.

4" MIN.

 

4 mm)

 

0" MIN.

RGURE&

9

Page 9
Image 9
Kenmore 153.336465, 336801 HA, 336901 HA, 761, 153.336361 Facts to Consider About Location, Fire or Explosion Hazard, Rgure

153.336501 HA, 336, 153.336161, 153.336301 HA, 336901 HA specifications

The Kenmore 153 is a standout model in the realm of home appliances, particularly noted for its exceptional performance and innovative features. This appliance is designed to meet the demands of modern households, combining efficiency, reliability, and user-friendly features into one compact unit.

One of the primary features of the Kenmore 153 is its robust design, which reflects its commitment to durability. Constructed with high-quality materials, it is engineered to withstand the rigors of daily use while maintaining a sleek and stylish appearance. This model comes with a powerful motor that guarantees efficient operation, enabling users to complete tasks quickly and effectively.

The Kenmore 153 incorporates advanced technology that enhances its functionality. For example, it features smart sensor technology, which automatically detects load size and adjusts water and energy usage accordingly. This not only conserves resources but also ensures optimal cleaning performance with every use. Additionally, the model offers multiple wash cycles and temperature settings, giving users the flexibility to customize their washing experience based on the fabric type and soil level.

Energy efficiency is a significant aspect of the Kenmore 153's design. It boasts an ENERGY STAR certification, indicating that it meets stringent energy efficiency guidelines set by the U.S. Environmental Protection Agency. This not only helps reduce utility bills but also minimizes the environmental impact, making it a wise choice for eco-conscious consumers.

The Kenmore 153 also prioritizes user convenience. Its intuitive control panel allows for easy navigation through various settings and options. A display screen provides clear information about the selected cycle and estimated time remaining, helping users manage their laundry tasks more effectively.

In terms of capacity, the Kenmore 153 is spacious enough to accommodate large loads, making it ideal for families and busy households. Its advanced cleaning system ensures thorough cleaning without damaging clothes, while the high spin speeds reduce drying time significantly.

Overall, the Kenmore 153 stands out for its combination of advanced technology, energy efficiency, and user-centric design. It is a reliable choice for those seeking a powerful and versatile appliance to enhance their laundry experience. Whether you are dealing with everyday clothing or specialized fabrics, the Kenmore 153 promises to deliver exceptional results with every use.