Problem Possible Cause Solution
Won't Drain/ Lowvoltage or using Check electrical source or call
Won't Spin/ an extension cord. electrician. Do not use an extension
Wet Loads cord.
(cont'd) Cold rinses, Cold rinses leave loads wetter than
warm rinses. This is normal.
Continues Drain hose is lessthan Raisethe drainhose
to Fill/ 39 inches above floor. (see "INSTALLATION','Section D).
Continues
to Drain/ Drain hose fits tightly into Adjust drain hose for loose fit
Cycle Stuck standpipe. (see "INSTALLATION','Section D).
Drain hose taped into Do notseal off drain hose with tape.
standpipe. The drain hose needsan air gap.
Washer Makes Loadis unbalanced. Redistribute load.
Noise Laundrycenter is not level. Levellaundry center
(see "INSTALLATION','Section I).
Floor notstrong enough Relocatelaundry center
to support laundry center. (see "INSTALLATION','Section A).
Gears engaging afterdrain This is normal.
and before spin.
Upperpart ofagitator clicks This isnormal.
during wash.
Won't Fill/ Water inlet valve Clean screens.
Won't Rinse/ screens are plugged.
Won't Agitate/
Wrong Wateris turned off. Turnonwater.
Temperature Hotand coldhoses are Reversehoses
reversed. (see"INSTALLATION','Sections E & F).
Inlet hose is kinked. Straighten hoses.
Timer dial is not lined up. Turn timer knobto the right slightly
and pull to start.
Powercord notplugged in. Plugin power cord.
55