Problem Possible Cause Solution
Machine Powercord notplugged in. Plug in power cord.
Stops Nopower at plug. Check electrical sourceor call
electrician.
Fuseblown orcircuit Replace fuse or reset circuit breaker.
breaker open. If problem continues,catl electrician.
Using an extension cord. Do not use an extension cord.
Timer is not lined up. Turn timer tothe right slightly
and pull to start.
Timer knob not pulled out. Setand pull out knob.
Washer at pause in Allow cycle to continue
PERMANENT PRESS Cycle (see"OPERATION").
(approximately two minutes).
Machine is overloaded. Wash smaller loads.
Agitator Not The top of the agitator moves Thisis normal.
Working only in one direction.
The top of the agitator isloose. This is normal.
Water Level The top ofthe agitator is much This isnormal.
Too Low/Not higher than the highest water
Completely level. This creates a perception
Filling of the washer not being full.
Tub is Tub pulled forward when Ensure tub iscentered before
Crooked unloading, starting washer.
Tub moves. This is normal.
Laundrycenter not level. Ensure leveling legsare installed.
Level laundry center
(see "INSTALLATION','Section I).
Lint on Load Impropersorting. Sort lintgivers from Iint takers
and by color.
Overloading. Lintcanbe trapped in load if
overloaded.Wash smaller loads.
Paper ortissue in pockets. Clean out pockets before washing.
Not enough detergent. Useenough detergent to
hold Iint in water.
Detergent not dissolving. Use wash waterwarmer than70°E
56