STORAGE
•Follow cleaning instructions
•Remove the exhaust hose and window kit and repack the unit in its original shipping box. Store unit upright in a dry place where the temperature will remain above 35°F.
•IMPORTANT: Always store and transport the unit so as to maintain the compressor in a upright orientation.
TECHNICAL SPECIFICATIONS
MODEL | 408.72012 | |
VOLTAGE | 120V~60Hz | |
AMPERAGE: |
| |
COOLING | 12 Amps | |
HEATING | 10.5 Amps | |
|
| |
POWER CONSUMPTION: |
| |
COOLING | 1400W | |
HEATING | 1200W | |
COOLING CAPACITY | 12,000BTU/h | |
HEATING CAPACITY | 12,000BTU/h | |
|
| |
DEHUMIDIFYING CAPACITY(30ºC, RH80%) | 126.8 Pints/Day (60 Liters/Day) | |
|
| |
NOISE LEVEL (Indoor use) | 53 dB(A) | |
AIR CIRCULATION (m3/h) | 265 CFM maximum at high | |
fan speed | ||
| ||
REFRIGERANT | R410A | |
|
| |
REMOTE CONTROL | INCLUDED | |
|
| |
TIMER | ||
|
| |
DIMENSIONS (WxDxH) | 21.7” x 12” x 29.9”/ | |
55cm x 30cm x 76cm | ||
| ||
NET WEIGHT | 65 lbs/29.5 kg | |
|
|
TROUBLESHOOTING
If your air conditioner fails to operate, please follow these procedures prior to contacting customer service.
DO NOT ATTEMPT TO OPEN OR REPAIR THE AIR CONDITIONER YOURSELF. DOING SO WILL VOID THE WARRANTY AND CAUSE DAMAGE OR PERSONAL INJURY.
PROBLEM | POSSIBLE CAUSE | SOLUTION |
|
|
|
Can I turn the unit on immediately |
| No. The unit must be placed upright |
after unpacking it? |
| for at least 12 hours after every |
|
| transport. Otherwise the compressor |
|
| may be damaged. |
|
|
|
Unit does not start when pressing | Room temperature is higher | Lower the set temperature |
power button | than the set temperature |
|
| (heating mode). |
|
| Room temperature is lower | Raise the set temperature |
| than the set temperature |
|
| (cooling mode). |
|
|
|
|
The air conditioner does not | No electricity | Check house circuit breaker panel |
come on |
| for tripped switch. |
| It is not plugged into the | Plug into outlet |
| outlet |
|
| The internal safety device | Wait 30 minutes; if problem persists, |
| has tripped | call |
|
| product inspection and repair. |
| The safety device on the | Reset the safety plug |
| plug has tripped |
|
|
|
|
The air conditioner works for only | There are bends or kinks in | Position the air hose correctly, |
a short time | the air exhaust hose | keeping it as short and free of |
|
| curves as possiuble to avoid |
|
| bottlenecks. |
| Something is preventing the | Check and remove any obstacles |
| air from being discharged | obstructing air discharge. |
|
|
|
Room is not cool enough | Windows/doors in room | Close all windows/doors |
| are open |
|
| There are heat sources | Remove heat source if possible |
| nearby |
|
| Exhaust hose is not | Connect the exhaust hose and make |
| connected or is blocked | sure it can function properly |
| Temperature setting is too | Decrease the set temperature |
| high |
|
|
|
|
The air conditioner does not | Air filter blocked by dust | Clean the air filter |
operate for about three minutes | The compressor control | Wait. This delay is part of normal |
after restarting it | prevents the unit from | operation |
| being restarted until three |
|
| minutes have elapsed since |
|
| it was last turned off |
|
|
|
|
Noise or vibrations | The floor is not level or the | Place the unit on a flat, level surface |
| unit is on an incline |
|
|
|
|
Gurgling sound | The sound comes from | This is normal |
| the flowing of refrigerant |
|
| inside the air conditioner |
|
|
|
|
20 | 21 |
