UNPACKING INSTRUCTIONS
ACCESSORIES
1. | Place the unit in the correct upright |
| position before unpacking. |
2. | Cut the two packing straps. |
Carry |
Handles |
On initial unit setup, check that all the accessories listed below are included:
3. | Slide the carton in an upward motion |
| and it will release from the base. |
| (We recommend that you retain the |
| packaging for offseason storage) |
4. | Grip the unit by the recessed carry |
| handles on each side, and carefully lift |
| unit until it slides free from foam base. |
Exhaust hose
Remote sensor kit
(used only in
2 AAA batteries
Drain hose for continuous drainage
(16 mm inner diameter)
Window kit (3 pcs)
Remote control
AIR CONDITIONER PARTS
Remove the air conditioner from the packing carton. It is recommended to keep the carton and packing material for storage or transportation of the unit.
INSTALLATION
| (4) | |
| (5) | |
(2) |
| |
(1) | (8) | |
(3) | ||
(7) | ||
| ||
| (6) |
Fig. 1
Front of Unit (Fig. 1)
1. Control Panel 2. Remote receiver 3. Adjustable air vent 4. Hose joint
5. Exhaust hose
6. Upper drain outlet 7. Carry handles
8. Remote receiver jack
Prior to installing the unit, check for the following:
1.To avoid damage, place the unit in an upright position for at least 12 hours before initial operation. This ensures all lubricating oil has settled to the bottom of the compressor, avoiding damage to other internal parts.
2.Lift the exhaust hose holder (1) from the unit to expose the exhaust hose and accessories. Remove the accessories from the hose and set aside. Turn the hose in the direction of arrow (2) to completely remove the hose from the unit. Return the exhaust hose holder to the unit.
3.The hose has a window connection end and a unit connection end. Expand the unit connection end and insert it into the exhaust hose holder. Turn the hose several turns in the direction of arrow (3) until it is securely attached
in the holder.
(1)
(2)(3)
(14) | (9) |
| |
| (10) |
| (11) |
| (12) |
Fig. 2
(13)
Rear of Unit (Fig. 2)
9. Cool air inlet 10. Cool air filter 11. Warm air inlet 12. Warm air filter 13. Lower drain outlet 14. Exhaust hose holder
8
4.Plug the unit into a 120V~60Hz grounded electrical outlet. DO NOT USE A REGULAR EXTENSION CORD. If it is necessary to use an extension cord with this unit, use an approved air conditioner extension cord only.
9
