INSTALLATION REQUIREMENTS INSTALLATION HARDWARE
Your air conditioner will install into standard double
hung windows with actual clear opening widths of
22 to 36 inches (558mm to 914mm) (FIG. 1).
Lower sash must open sufficiently to allow a clear vertical opening of 14 inches (356mm). Side louvers and the rear of the air conditioner must have clear
air space to allow enough airflow through the condenser for heat removal. The rear of the unit
must be outdoors, not inside a building or garage.
14" min | Inner sill | Winddow |
| Offset | |
|
| |
|
| Sill |
|
| t |
|
| Exterior |
|
| FIG, I |
ELECTRICAL SERVICE
Check your available electrical service. The power supply available must be the same as that shown on the unit nameplate (found on left side of cabinet).
All models are equipped with a
ITEM | NAME OF PARTS | Q'TY |
A | SHORT SCREW | 11 |
B | WOOD SCREW | 5 |
C | L BRACKET | 3 |
D | FOAM STRIP | 1 |
E | FOAM SEAL | 1 |
F | SIDE CURTAIN | 2 |
G | DRAIN PIPE | 1 |
H | SUPPORT BRACKET | 1 |
plug, call a qualified electrician to make the necessary corrections. SAVE CARTON and this OWNER'S MANUAL for future reference. The carton is the best
way to store unit during winter or when not in use.
IT:
To avoid risk of personal injury,propertydamage, or )roduct damage dueto the weight of this deviceand sharp edgesthat may beexposed:
•Air conditionerscovered inthis manual pose an
excessiveweight hazard. Two or more peopleare neededto moveand installthe unit.
To preventinjury or strain, use properlifting and carryingtechniqueswhen movingunit.
•Carefully inspect locationwhere air conditionerwill be installed. Besure it will supportthe weightof the unit over an extendedperiod of time.
•Handle air conditionerwith care. Wear protective gloveswheneverlifting or carryingthe unit. AVOID the sharp metalfins of front and rearcoils.
•Make sure air conditionerdoes not fall during installation.
REQUIRED TOOLS:
•Tight Fitting gloves
•Standard screwdriver
•Phillips screwdriver
•Pliers
•Sharp knife
•
•
•Tape measure
•Electric drill
•
