Kenmore 580.75051 owner manual Installation, Bracket Drainage, Foam Strip, Locating Unit in Window

INSTALLATION

Picka locationwhich will allow you to blow the cold air into the area you want. Windows usedfor installation must be strong enough to supportthe weight of the air conditioner. Good installationwith special attention to the properposition of the unit will lessen the chance that servicewill be needed. If air conditioneris blockedby a storm window frame, see step 9 on page 7 before beginningto install.

HOW TO INSTALL

U SIDE CURTAINS

Insert the side curtains into the upper and lower guides of the air conditioner. Fasten the curtains to the unit with screws (ITEM A), as shown in FIG. 2.

ITEMA FIG. 2

_'_ FOAM STRIP

Cut the adhesive-backed foam strip (ITEM D) to the window width.

Remove the backing from the foam strip and attach the foam strip to the underside of the bottom window. (FIG. 3)

FIG. 3

_'_ LOCATING UNIT IN WINDOW

Open the window and mark center line with pencil on the center of the inner sill, as shown in FIG. 4.

INNER SILL

ROOM SIDE

FIG. 4

L_I ATTACH L BRACKET

•Install the L brackets on the outer sill with the short side of the bracket against the back of the inner sill. Install one L bracket 8" to each side of center line. See FIG. 5.

•The bracket helps to hold unit securely in place.

Be sure to place bracket edge flush against back of inner sill. See FIG. 5.

•If air conditioner is blocked by storm window frame, see step 9.

INNER SILL

OUTER SILL ITEM A INSIDE

LINE

f

SHORT SIDE

OUTSIDE

L BRACKET FIG. 5

DRAINAGE

First, be sure to insert the drain pipe into base pan before installation.

The air conditioner must be installed with a slight tilt downward (see FIG. 8) for proper water drainage. The air conditioner will drain the excess condensed

water through the drain pipe.

DRAINCAP

DRAINPIPE

_BASE PAN REAR

DRAIN _,__

FIG. 6

-6-