Kenmore 580.75080 owner manual Installation, HOW to Install, Bracket Drainage

INSTALLATION

Pick a location which will allow you to blow the cold air into the area you want. Windows used for installation must be strong enough to support the weight of the air conditioner. Good installation with special attention to the proper position of the unit will lessen the chance that service will be needed.

If air conditioner is blocked by a storm window frame, see step 9 on page 7 before beginning to install.

HOW TO INSTALL

HSIDE CURTAINS

Insert the side curtains into the guides of the air conditioner. Fasten the curtains to the unit with screws (ITEM A), as shown in FIG. 2.

ITEM A FIG. 2

_FOAM STRIP

Cut the adhesive-backed foam strip (ITEM D) to the window width.

Remove the backing from the foam strip and attach the foam strip to the underside of the bottom window. (FIG. 3)

FIG. 3

_J LOCATING UNIT IN WINDOW

Open the window and mark center line with pencil on the center of the inner sill, as shown in FIG. 4.

QATTACH L BRACKET

•Use screws(ITEM A) to install the L brackets on the outer sill as shown. See Fig. 5.

•The bracket helps to hold unit securely in place.

Be sure to place bracket edge flush against back of inner sill. See FIG. 5.

•If air conditioner is blocked by storm window frame, see step 9.

INNER SILL

OUTER SILL	ITEM A INSIDE
	},ENTER LINE

OUTSIDE

L BRACKET FIG. 5

DRAINAGE

First, be sure to insert the drain pipe into base pan before installation. The air conditioner must be

installed with a slight tilt(l/4") downward for proper drainage of excess condensed water through the drain pipe.

tDRAINCAP

DRAINPIPE

REAR

DRAHN PHPE

\

BASE PAN BOTTOM

INNER SILL

_r

ROOM SIDE

FIG. 4 FIG. 6

-6-