Kenmore 580.75281 Control Panel, Mode, Remote Control Signal, Receiver, Temperature Setting

CONTROL PANEL

_FAN SPEED

• Every time you push this button, it advances the setting as follows: {High _Low _Med _High}

	REMOTE CONTROL SIGNAL
	RECEIVER
	TEMPERATURE SETTING
	• Use this button to automatically control the
	temperature of the room.
	The temperature can be set within a range
	of 60°F to 86°F by increments of 1°F.
	• The setting appears in the display.
	POWER
	• To turn the air conditionerON, push the button.
	To turn the air conditionerOFF, push
f	the buttonagain.
LTIMER	• This buttontakes priority over any other button.
- SHUT-OFF TIME	• When you first turn it on, the air conditioneris on
• You will usually use shut-off time while you sleep,	the Highcool mode andthe Temp. at 72°F.
• If unit is running, usetimer to set number of hours until shut-off.	• Auto restart
• For your sleepingcomfort,oncetimer is set, thethmperature	In the event as a powerfalture,the unit will run
settingwill raige2°Fafter 30minand onceagainafter another30min.	at the previoussetting once power returns.

• Push timer buttonto advance setting from 1 Hour * 2Hour..... d2 Hours maximum.

- START TIME

•If unit is off, Timer sets numberof hours before unit starts.

•Push timer buttonto advance setting from 1 Hour _2Hour..... d2 Hours maximum.

MODE

-Push this button to shift mode of operation from cool * energy saver * fan.

-ENERGY SAVER:

•The fan stops when the compressor stops cooling.

Approximately every 3 minutes the fan will turn on so that the unit can check the room air to determine if cooling is needed.

In failure		of	electric	power, the	unit runs as	previous setting	operation.	J
HORIZONTAL			AIR	DIRECTION	CONTROL	VERTICAL	AIR DIRECTION CONTROL
The	horizontal		air direction is adjusted by moving			The vertical	air direction is adjusted by moving	the
						horizontal louvers up and down with your fingertips.
the	vertical	louvers right and left with your				(FIG. 25)
fingertips.		(FIG. 24)

FIG. 24 FIG. 25

-11 -