INSTALLATION
Pick a location which will allow you to blow the cold air into the area you want. Windows used for installation must be strong enough to support the weight of the air conditioner. Good installation with
special attention to the proper position of the unit will lessen the chance that service will be needed.
When cooling more than one room, installation
location is very important. To cool your rooms, cold air must be blown from the air conditioner in a
straight path.
Lastly it is adviced to save the shpping carton for future storage of the unit.
HOW TO INSTALL
If the air conditioner is blocked by a storm window frame, see step 16 on page 8 before beginning to install.
ORemove the screws which fasten the cabinet at the back and side of the unit. Save side screws.
Discard back screws.
FIG. 3
_ Slide the unit out of the cabinet by gripping the base pan handle and pull forward while bracing the cabinet.
FIG. 4
i_"_ Cut the FOAM SEAL (ITEM J) to fit the underside of the window sash. Peel off the backing and attach the FOAM SEAL as shown in Fig. 5.
..... Sash
FIG. 5
L_I Insert the side curtains (ITEM A) into the upper guide and lowerguide on each side of the air conditioner cabinet. Fasten the curtains to the unit with screws (ITEM E).
ITEM E
Lower Guide
ITEM E FIG, 6
_Open the window. Mark a line on the center of the
window inner sill. Loosely attach the sill bracket (ITEM C) to the support bracket (ITEM B) using the carriage bolt (ITEM I) and the lock nut (ITEM D).
ITEM
ITEM I
r'_ Attach the sill bracket to the window sill using the
screws (ITEM F). Carefully place the cabinet on the window inner sill and align the center of the cabinet front with the center line marked on the window inner sill.
| /Machine | screw(ITEMH) |
Cabinet_ | /and locknut (ITEMD) | |
trackhole | _Outer | |
| /edge | of |
ITEM | windowsill | |
Carriagebolt................J | Sillbracket | FIG. 8 |
andlocknut | ||
H Using the
(ITEM D), attach the support bracket to the cabinet track hole. Use the first track hole as shown. Tighten the carriage bolt and the lock nut. Be sure the cabinet slants downward 1/4" from level.
CAUTION: Do not drill a hole in the base pan. The unit is designed to operate with approximately 1/2" of water in base pan.
Lowerguide
Cabinet
INDOOR | OUTDOOR | FIG. 9 |
