Kenmore 580.75281 owner manual How To Insert Batteries Into Remote Control, Timer, Mode

Models: 580.75281

1 32
Download 32 pages 16.86 Kb
Page 12
Image 12
REMOTE CONTROL

REMOTE CONTROL

NOTE: The Remote Control will not operate properly if strong light shines on the sensor window of the Air Conditioner or if there are obstacles between the Remote Control and the Air Conditioner.

Every time you push button, you will hear a beep from the Air Conditioner.

POWER

To turn the air conditionerON, push the button.

To turn the air conditioner OFF, pushthe button again.

This buttontakes priority over any other button.

When youfirst turn it on,the air conditioneris on the Highcool modeandthe Temp.at 72°F.

Auto restart

In the event asa powerfalture,the unit will runat the previoussettingonce powerreturns.

TEMPERATURE SETTING

Use this button to automatically control the temperature of the room.

The temperature can be set within a range of 60°F to 86°F by increments of 1°F.

The setting appears in the display.

FAN SPEED

h

 

• Every time you push this button it advances the setting as follows:

1,

(High * Low * Med _ High)

 

TIMER

....

• You will usually use shut-off time while you sleep.

 

• If unit is running, usetimer to set number of hours until shut-off.

 

• For yoursleeping comfort, oncetimer is set, thethmperature

 

setting will raige 2°Fafter 30min andonce again after another30min.

 

Pushtimer button to advance setting from 1 Hour _2Hour..... .12 Hours maximum.

- START TIME

If unit is off, Timer sets number of hours before unit starts.

Pushtimer button to advance setting from 1 Hour * 2Hour..... .12 Hours maximum.

FAN SPEED

TIMER MODE

MODE

-Push this button to shift mode of operation from cool _energy saver _fan.

-ENERGY SAVER:

The fan stops when the compressor stops cooling.

Approximately every 3 minutes the fan will turn on so that the unit can check the room air to determine if cooling is needed.

HOW TO INSERT BATTERIES INTO REMOTE CONTROL

1.Remove the cover from the back of the remote controller.

Open the cover according to the arrow direction on the cover.

2.Insert two batteries.

Be sure that the (+) and (-) directions are correct.

Be sure that both batteries are new.

3.Re-attach the cover.

Do not use rechargeable batteries.

Such batteries differ from standard dry cells in shape, dimensions, and performance.

Remove the batteries from the remote controller if the air conditioner is not going to be used for an extended length of time.

The remote control can be mounted on a wall using the mountable holder.

-12-

Page 12
Image 12
Kenmore 580.75281 owner manual How To Insert Batteries Into Remote Control, Timer, Mode