QSelect the position that wilt place the sill supports near the outermost point on sill (FIGo10)
Attach the sill supports to the cabinet track hole closest to the selected position using screw (ITEM E).
Lower guide, ,, _. _,_&
' / | 'N |
CaNnel
_ Place the sill supports with the cabinet on the window sill'sselected position
_ti] The cabinet should be installed with a very slight tilt (about 1/4") downward toward the outside (FIG 11),,
Adjust the bolts and the nuts of sill supports to level the cabinet.,
_] Attach the L BRACKET (ITEM J) with screw
(ITEM G).,(FIG, 14)
/]II ,TEM
_ | FIGo 14 |
_] DRAINAGE
Be sure to insertthe drain pipe into base pan before installation.,
The air conditioner must be installed with a slight tilt downward to the outside for proper water drainage° The air conditioner will drain the excess condensed
water through the drain pipe (FIG, I5)
DRAINp_BASE | PAN REAR |
J _
TEMB FIG. 11
_ Attach the cabinet to the inner sill by driving the
screws (_TEM F) through the front angle into the window inner sill (FIG, 12),,
i I:I Ir
| . |
I_ | tTEM F |
ITEMB | FIG. 12 |
[]Pull each side curtain fully to each side of
window opening
Attach each side curtain to the window sash using screws (ITEM G). (FIG, 13)
ITEM G
FIG. 13
FIG. 15
_ Slide the chassis into the cabinet. (FIG. 16)
CAUTION: For security purposes, reinstall side screws you removed in step I.
[_r
Screw "_,,_
Screw FIGo16
_Cut the foam strip (ITEM H) to the proper length
and insert between the upper window sash and the lower window sash,, (FIG, 17)
FIGo17
_The vent control handle must be straightened
before the decorative front is attached
Putl out part @ to align with part (_.
.Part(
FIG. t8