Kenmore 625.38556 owner manual Select Location Of Reverse Osmosis Faucet Mounting Hole

SELECT LOCATION OF REVERSE OSMOSIS

FAUCET MOUNTING HOLE

You will need to select the location of the Reverse Osmosis Faucet. You have three options to choose from:

•Use the existing sink top hole for the spray hose or soap dispenser (Must be 1-1/4" in diameter)

Drill a new hole in the sink

Drill a new hole in the countertop next to the sink

. Determine where you are going to install your Reverse Osmosis Faucet.

2.Check to ensure the Reverse Osmosis faucet will mount flat against the mounting surface.

3.Visually review the routing of the tubes from the Reverse Osmosis filter assembly to the faucet. Check to ensure there is adequate tube routing space between the faucet and filter assembly.

4.if drilling is needed, drill a 1-1/4" diameter hole in the mounting surface.

IMPORTANT." Drilling holes into countertops and sinks should only be performed by a qualified installer who is certified for drilling such materials. Drilling of surfaces made of stone or solid surface materials such as granite, marble, Corian _Mor other plastic resin prod- ucts or sinks made of porcelain and stainless steel may cause permanent, irreparable damage to the sink or countertop surface.

INSTALL REVERSE OSMOSIS FAUCET

1.Locate and organize your RO faucet install parts. Refer to Figure 13.

2.Mount faucet base to sink hole until the faucet base is

square against the sink surface. The rubber washer should be between the sink surface and the faucet

base.

3.Tighten the toggle bolts until the base is firmly mount- ed to the sink surface. Do not overtighten.

4.Feed a length of 3/8" blue tubing up through the hole and connect to the 3/8" quick connect fitting on the bottom of the faucet. See Figure 14.

5.Feed a length of 1/4" red tubing up through the hole and connect to the 1/4" barb on the bottom of the faucet. See Figure 14.

6.Connect the length of 3/8" black tubing to the 3/8" barb on the bottom of the faucet. See Figure 14.

faucet

						faucet base
						1/4	turn	to connect
	screw		/q__		_'/"	_faucet		base
			'
_	_	__			_		rubber	washer
toggle	bolt	_			_
		,r ' / -_-_					_ndecti_l		_lect r°nics
hole in sink or__4_
countertop			i		,
3/8" BLACK tubing-_"_/J				k k_k_"_'_l/4"				RED	tubing
3/8" BLUE	tubing_		/	\'		\

Figure 13

Questions? Call The Kenmore Water Line 1-800-426-9345or visit KenmoreWater.com

12