water supply fitting
3/8" black tubing | _ | |
| II |
|
| II | 1/4" red tubing |
| II | |
|
| / |
|
| blue tubing |
CE) | CE) |
|
i IOT | COLD |
|
| / |
|
sink | 1/4" green tubing | |
NOTE: Tubing lengths should allow access to the back of the assembly for servicing.
NOTE: Codes in the state of Massachusetts require installation by a licensed plumber and do not permit the use of saddle valves. If you live in the state of
Massachusetts, review plumbing code
the Commonwealth of Massachusetts before pro- ceeding with the installation.
3/8" yellow tubing
connector
Tube Connections
CONNECT YELLOW TUBE TO STORAGE TANK
1.Locate the yellow tube. One end is attached to the Reverse Osmosis filter assembly.
2.Run the other end of the yellow tube to the fitting on top of the storage tank. See Figure 21.
3.Cut tube square and to length. See Figure 16.
4.Do not connect at this time. This will occur in the sanitizing step.
CONNECT GREEN TUBE TO COLD WATER SUPPLY PIPE
1.Run one end of the 1/4" green tube to the fitting on the water supply pipe. See Figure 21.
2.Cut tube square and to length. See Figure 16.
3.Connect to saddle valve. This is a compression fitting.
CONNECT RED TUBE TO REVERSE OSMOSIS
FAUCET
The red tube cortnection was completed in the faucet assembly steps.
Figure 21
CONNECT BLUE TUBE TO REVERSE OSMOSIS ASSEMBLY
The blue tube cortnection was completed in the faucet assembly steps.
CONNECT BLACK TUBE FROM REVERSE OSMOSIS
FAUCET TO DRAIN ADAPTER
1.Locate the 30" length of 3/8" black tube. One end is attached to the faucet. Figure 21.
2.The other end needs to be attached to the black collet on the sink drain adapter.
3.Cut this tube as needed to route in as straight of a run as possible, without loops, dips, low spots or kinks.
4.Cut the end of the tube square. See Figure 16.
5.Insert all the way into the fitting. See Figures 17 & 18.
6.Pull on the tube to be sure it is held firmly in the fitting.
Questions? Call The Kenmore Water Line
15
