-STEP 5: INSTALL STORAGE TANK, MAKE REMAINING TUBING CONNECTIONS -
1. CONNECT DRAIN TUBING, FAUCET TO
DRAIN ADAPTER: Referring to Figure 10, run the loose section of black 3/8" tubing from the faucet to
the drain adapter, with a black collet, installed on
page 6. Cut this tubing as needed to route in as
straight of a run as possible, without loops, dips, low spots or kinks. Cut the end of the tubing square. Then push all the way into the fitting. Pull on the tub- ing to be sure it's held firmly in the adapter fitting.
See page 16 for tubing connection instructions.
2. CONNECT TUBING TO WATER SUPPLY: Con- nect the feed (green) tube to the water supply fitting
installed on page 5. Connection to the fitting is as
RO product water faucet
UltraFilter 350 2_
water supply
fitting | drain |
| |
| adapter |
| HOT COLD |
| sink |
tubing adaptor | yellow collet |
described in Figure 14, page 16.
3.Move the storage tank into place next to the RO as-
sembly. You can stand the tank upright, or lay it on side. Apply no more than two wraps of Teflon tape
to the threads on the nipple at the top of the tank.
Hand tighten the other included tubing adapter fit-
ting with the yellow collet onto the tank nipple, then
wrench 1/4 turn only. BE CAREFUL NOT TO CROSS THREAD.
4.Run the 3/8" yellow tubing to the fitting installed in step 3. Be sure the end of the tubing is cut square, and insert all the way into the fitting. Again, pull on the tubing to be sure it's held firmly in the fitting.
TYPICAL UNDERSINK INSTALLATION
RO product water faucet
UltraFilter 150
3/8" BLACK TUBING
Note: See note on page 4
regarding tubing lengths.
Figure 10
10
Problems, Questions? Call
