- STEP 3: INSTALL FAUCET (cont.)-
UltraFilter 350
channel
locking tabs
valve lever
FAUCET ELECTRONICS
The faucet will measure the length of time the filters
have been installed (6 months). The faucet has an in-
dicator LED that flashes to inform you of the status of the filter.
Green - Filter is good. Red - Filters need replacing.
In order to reset the monitor time feature, the battery
should be removed for a minimum of five seconds and then reinserted.
The battery needs to be replaced when indicater LEDs no longer light. Use only 3 volt sealed lithium
batteries. Improper placement of battery could dam-
age electronics. Use care when inserting battery to align it correctly.
To change the battery, pull the spout and bezel from the faucet base. The bezel will stay on the spout. Pinch the two tabs (under bezel on faucet) with one hand and with the other, pull up on the knob.
Change battery. Assemble the the knob, and spout and bezel back onto the faucet base.
Figure 8
- STEP 4: INSTALL RO ASSEMBLY -
Hang the assembly on the included hanger washers, or lay on the cabinet floor, as desired.
1.Refer to Figure 9 for wall mounting. Hold the as- sembly up to the wall surface and mark locations for
the hanger | washers. | Distance | needed | is 7.2" | ||
(approx. | apart. |
|
|
| ||
2.Install hanger washers at least
filter heads. Wood screws are provided, or obtain
other fasteners as needed.
up from floor
Figure 9
9
Problems, Questions? Call
