STEP 3:
PREPARE THE VENTING BLOWER
WALL VENTED INSTALLATION:
1.Remove one blower unit mounting screw and two blower plate screws. Remove the blower plate from cabinet. See Figure 12.
2.Carefully lift the blower unit out of the microwave oven. Disconnect the blower wire from connector. See Figure 13.
3.Use side cutters or tin snips to cut and remove knockouts "B" from Back plate. Discard knockouts. Be careful not to distort the plate. See Figure 14.
4.Rotate the unit so that the exhaust ports face the rear of the cabinet. See Figure 15. Before you insert blower unit, blower wire must be like
Figure 15.
5.Reassemble the blower wire into the connector.
_back plate
blower unit
blower plate mounting screws
Knockouts "B"
"%L.
blower plate blower unit mounting screw
Figure 12
.blower wire
6.Place blower unit back into cabinet. Check that the exhaust ports face towards the rear of the cabinet. See Figure 16.
7.Reattach the blower plate to the top of the cabinet as it was originally assembled. Attach with one blower unit mounting screw and then two blower plate mounting screws.
See Figure 17.
8.Go to STEP 4, PREPARE THE WALL AND UPPER CABINET FOR INSTALLATION located on page 13.
Knockouts Parts "B"
Figure 14
exhaust ports
Figure 16
connector
Figure 13
blower unit
exhaust ports
Figure 15
blower plate mounting screws
Y
blower unit _.,_.._._%_ exhaust ports
blower unit
mounting screw
Figure 17
11