STEP 5: INSTALL THE MOUNTING PLATE TO THE WALL
THE OVEN MUST BE CONNECTED
TO AT LEAST ONE WALL STUD.
1.Draw a vertical line on the wall at the center of the 30" wide space.
Use the mounting plate as the template for the rear wall. Place the mounting plate on the wall, making sure that the tabs are against the bottom of the cabinet. Line up the notch and center line on the mounting plate to the center line on the wall.
2.While holding the mounting plate with one hand, draw circles on the wall at holes "A", "B", "C" and "D". Four holes must be used for mounting. If the holes are not used, the installation will not be secure. Installer must use these holes for proper installation. Use toggle bolts through these holes unless one of them lines up with a stud. Use a wood screw for studs. See Figure 26.
NOTE: Draw a fifth circle inside area "E", through one of the holes to match the location of a stud.
For wall vented: The oven requires a rear wall cutout opening for the rear wall duct and the exhaust adaptor must be attached to the mounting plate. See the next page on how to prepare the rear wall cutout opening and the exhaust adaptor/mounting plate for wall vented.
3.Drill holes through the circles. If there is a stud, drill a 3/16" hole for lag screws. Two or preferably four lag screws at holes "A" and "C", or "B" and "C" must be used to secure mounting plate to wall. If there is no stud, drill a 3/4" hole for toggle bolts. Make sure to use at least 1 lag screw at holes of area "E" in a stud, and 4 toggle bolts at holes "A", "B", "C" and "D" in the drywall or the plaster.
4.Attach the plate to the wall. To use spring toggle head bolts: Remove the toggle wings from the bolts. Insert the bolts into the mounting plate and replace the spring toggle heads to 3/4" past the bolt ends. Insert the spring toggle heads into the holes in the wall to mount the bracket. You may pull forward on the bracket to help in tightening the toggle bolts. Tighten all bolts. See Figure 27.
|
| 3/16" | Hole on Studs |
|
| 3/4" Hole on Dry wall Only | |
hFMoinimr?l_em66'or1 | II h |
| |
I | I | m | |
|
|
| For Wall- |
Vented Only
/ |
| t |
| i | |
/ |
| t |
| t | |
Mounting | t | |
/ | _L | |
Plate |
| |
( |
| |
/[_ Center Line |
|
|
l | [ | [] | J | ) |
Support Tab |
| Support Tab | ||
| (3 pieces | mounting | plate) |
|
Figure 26
|
| Space More Than Watt Thickness | |
| I | Toggle | Wings |
Mounting | .... i | __ | ,(I t |
Plate'lY:! J,,, Toggle Bolt {k
Figure 27
15
