Installation
Figure 6. Modifying Mobile Home Window
1.Indoor sash (shown open)
2.Wood strip (1½" wide)
3.Window sill
4.Window frame
2
4
2.See Figure 8. Thread adjusting foot (Item B) through bottom of support bracket (Item C). Measure width of window and mark center point of outside sill.
Figure 8. Support Bracket Assembly
1.Support bracket
2.Adjusting foot
/
I
2
Installation Procedure
1.See Figure 7. Raise indoor sash and measure sash width, including portion in window track. Cut window sill gasket (installation Kit Item A) to length of indoor sash and apply to rear of indoor window sill. To apply gasket, peel back about 2" of paper covedng gasket adhesive, and carefully press exposed adhesive to one end of window sill. Slowly peel away remaining paper cover from gasket adhesive, and press gasket to sill as paper is pulled away.
If window has been modified for installed storm window, apply gasket to wood strip added to sill.
For mobile home installation, apply gasket to outdoor side of window frame bottom lip.
Figure 7. Applying Window Sill Gasket
1.Indoor sash
2.Indoor sill
3.Paper covering gasket adhesive
4.Gasket
3.See Figure 9. Center support bracket on outside sill, 1_/16"from rear edge of indoor sill. Secure bracket to outdoor sill with 2
Figure 9. Installing Support Bracket
1.13/16"gap
2.Center of window
3.
4.Bubblelevel
4
\
2
/
\
4
