Kenmore 790-9663 manual Setting Oven Controls, Setting the Clock, Pressdisplay, Instructionspress

Setting Oven Controls

•Setting the Clock

•Changing between 12 or 24 hour display

•Silent Control Operation

Setting the Clock

The CLOCK pad is used to set the clock. The clock may be

set for 12 or 24 hour time of day operation. The clock has been preset at the factory for the 12 hour operation. When the range is

first plugged in, or when the power supply to the range has beenFig. 1 interrupted, the timer in the display will flash (See Fig. 1).

INSTRUCTIONS

To set the clock (example below for 1:30):

1.Press . "CLO" will appear in the display (See Fig. 2).

2.Press pads to set the time of day to 1:30

(See Fig. 3). Press . "CLO" will disappear and the clock will start (See Fig. 4).

Changing between 12 or 24 hour time of day display:

PRESSDISPLAY

Fig. 2

Fig. 3

ENGLISH

1.	Press and hold		for 6 seconds untill "12h" or "24h"
	appears in the display.
2.	Press	to switch between the 12 and 24 hour time of day
	display. "12h" or "24h" will be displayed (See Figs. 5 or 6).

for 6 seconds

Fig. 4

3.	Press	to accept the desired change or press	to
	reject the change.
4.	Reset the correct time as described in To set the clock above.
	Please note that if the 24 hour time of day mode was chosen,
	the clock will now display time from 00:00 through 23:59 hours.

or Fig. 5

Fig. 6

Setting Silent Control Operation

The DELAY START and FLEX CLEAN pads control the Silent Control operation feature. The Silent Control

operation feature allows the oven control to be operated without sounds or beeps whenever necessary. If desired the control can be programmed for silent operation and later returned to operating with all the normal sounds and beeps.

INSTRUCTIONSPRESS

To change control from normal sound to silent control operation:

1. To tell if your range is set for normal or silent operation press
and hold	for 7 seconds. (See Fig. 7)	for 7seconds

2. Press to switch between normal sound operation and

silent operation mode. The display will show either "SP" (See Fig. 8) or " - -" (See Figs. 2 or 3).

If "SP" appears (See Fig. 2), the control will operate with normal sounds and beeps. If " - -" appears (See Fig. 9), the control is set for silent operation mode.

3. Press	to accept the change or press	to reject the	or
change.

DISPLAY

Fig. 7

Fig. 8

Fig. 9

21