Kenmore 790-9663 manual Warmer Drawer Removal, To Remove and Replace Warmer Warm Ready Drawer

Warmer Drawer Removal

•Removing & Replacing Warmer Drawer

To Remove and Replace Warmer (Warm &

Ready™) Drawer

Electrical Shock Hazard can occur and result in serious injury or death. Disconnect appliance from electric power before cleaning and servicing the warmer drawer.

To Remove Warmer Drawer:

	1.	Turn power OFF before removing the
		warmer drawer.
	2.	Open the drawer to the fully opened position.
	3.	On the right glide you will find a shield attached with a
		hex-head screw (See Fig. 1). Use a 1/4” socket and
		ratchet to remove the shield.
	4.	Locate glide lever on each side of drawer, pull up on the
		left glide lever and push down on the right glide lever.
	5.	Pull the drawer away from the range.
	To Replace Warmer Drawer:
	1.	Replace shield on the right glide of the drawer body.
	2.	Pull the bearing glides to the front of the chassis
		glide (See Fig. 2).
Fig. 1	3.	Align the glide on each side of the drawer with the glide
		slots on the range.
	4.	Push the drawer into the range until levers “click”
		(approximately 2”). Pull the drawer open again to seat
		bearing glides into position. If you do not hear the
		levers “click” or the bearing glides do not feel
		seated remove the drawer and repeat steps 2-4.
		This will minimize possible damage to the bearing
		glides.

NOTE: The Warmer Drawer will NOT operate while in the

Self-Clean and “Oven Lockout” modes

Fig. 2

38