Kenmore 790.7888 Setting Oven Controls, Setting the Clock, To set the clock example below for

Setting Oven Controls

•Setting the Clock

•Changing between 12 or 24 hour display

Cone Cenv Cony

Bake Roast Convert

_-_ _

1 2 3

4 5 6

Pre	Bake		Cook	Delay	Timer	Add 1	7	8	9
Heat		Broil
			Time	Start	Set/Off	Minute
W	"-_J	"--J
Slow	Warm &	Flex	Recal	@		@	STJZ0Cle t		@
Cook	Hold	Clean
			Recipe	0
						_	Oven
							Lockout

Setting the Clock

The CLOCK (_r_) pad is used to set the clock. The clock may be set for 12 or 24 hour time of

day operation. The clock has been preset at the factory for the 12 hour operation. When the range is first plugged in, or when the power supply to the range has been interrupted, the timer in the display will flash (See Fig. 1).

INSTRUCTIONS

To set the clock (example below for 1:30):

1.Press @. "CLO" will appear in the display (Fig, 2).

2.Press @ @ @ pads to set the time of day to 1:30(Fig. 3).

"CLO" will appear in the display. Press _. "CLO" will

disappear and the clock will start (Fig, 4).

Changing between 12 or 24 hour time of day display:

1.Press and hold {'Q} for 6 seconds (Fig. 3). While holding the

pad down the current time of day will remain and "CLO" will disappear from the display (Fig, 4). CONTINUE holding the pad until a beep is heard,

2.The display will show either "12h"(Fig. 5)or"24h"(Fig. 6).

3.Press c....ooto. switch between the 12 and 24 hour time of day

display, The display will show either "12h" (Fig, 5) or "24h" (Fig, 6).

4. Press _ to accept the desired change or press @ to

reject the change,

5.Reset the correct time as described in To set the Clock above. Please note that if the 24 hour time of day mode was chosen, the clock will now display time from 0:00 through 23:59 hours.

PRESSDISPLAY

@

®@@	Fig. 2
@
	Fig. 3
for 6 seconds
	Fig. 4
Clean	Fig. 5
	Fig. 6

13