Kenmore 790.922, 790.923, 790.921 Before You Call Solutions to common problems, Problem, section

Before You Call • Solutions to common problems

Problem	Solution
Oven smokes excessively when broiling.	• Incorrect setting. Follow broiling instructions in Setting Oven Controls
	section.
	• Be sure oven door is opened to broil stop position when broiling.
	• Meat too close to the broil element. Reposition the broil rack to provide
	proper clearance between the meat & the element. Preheat the broil
	element for searing.
	• Meat not properly prepared. Remove excess fat from meat. Cut remaining
	fatty edges to prevent curling, but do not cut into lean.
	• Grease has built up on oven surfaces. Regular cleaning is necessary when
	broiling frequently. Old grease or food spatters cause excessive smoking.

Flames inside oven or smoking from oven vent.

•Excessive spillovers in oven. For example this will happen for pie spillovers or large amounts of grease left on the oven bottom. Wipe up excessive spillovers before starting oven. If flames or excessive smoke are present follow broiling instructions in Setting Oven Controls section.

Oven control panel beeps & displays	• Oven control has detected a fault or error condition. Press		key pad to
any F code error.	clear the error code. Try Bake or Broil function. If the F code error repeats,
	remove power from appliance, wait 5 minutes and then repower appliance
	and set clock with the correct time of day. Try Bake or Broil function again.
	If the fault recurs, press	to clear and call 1-800-4-MY-HOME® for
	assistance (See back cover).
Select Clean does not work.	• Oven control not set properly. Review instructions in Select Clean section.
Soil not completely removed after	• Select Clean was interrupted. Review instructions in Select Clean section.
Select Clean.	• Excessive spillovers on oven bottom. Remove before starting Select Clean.

•Failure to clean soil from the oven frame, the door liner outside the oven door gasket and the small area at the front center of the oven bottom. These areas are not in the self-cleaning area, but get hot enough to burn on residue. Clean these areas before the self-cleaning cycle is started. Burned-on residue can be cleaned with a stiff nylon brush and water or a nylon scrubber. Be careful not to damage the oven gasket.

Oven racks discolored.	• Oven racks left in oven cavity during Select Clean. Always remove oven
	racks from oven cavity before starting a self-clean cycle. Clean by using a
	mild, abrasive cleaner following manufacturer's instructions. Rinse with clean
	water, dry and replace in oven.

29